Bedienungsanleitung Zanussi ta 850 (Seite 8 von 8) (Englisch)

314889

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

8. OPERATING PROBLEMS

Many checks have been carried out during the manufacture of your washing machine. However, if you face a problem with

its operation, please read the following sections before calling the After Sales Service:

If you are unable to identify or to solve the problem, consult

our services department. Before calling, inform yourself

about the model and the date of purchase of your appliance:

the services department will need this information.

Data plate

You will find this information on the data plate (at the back of

the appliance) and on a sticker located on the interneal door

filter.

Symptom Cause

The washing machine will not start or will not fill:

• the washing machine is not correctly connected, the electrical

installation is not working,

• the lid of your washing machine and the drum flaps are not cor-

rectly closed,

• you did not control the program start correctly,

• there is a power failure,

• the water supply is closed off,

• the water tap is closed,

• the water inlet is blocked.

The washing machine fills up but empties again immedia-

tely:

• the drain siphon is attached too low (see installation section).

The washing machine will not spin or will not drain:

• the drain pipe is blocked or kinked,

• the drain filter is blocked,

• the «Drain» program or the «Rinse hold» option is selected,

• the height of the drain siphon is wrong.

There is water on the floor around the washing machine:

• excess detergent has made too much foam that overflowed,

• the detergent is not suitable for machine washing,

• the drain siphon is not hooked on properly,

• the drain filter was not put back into place,

• the water inlet pipe is leaking.

Washing results are not satisfactory:

• the detergent is not suitable for machine washing,

• there is too much washing in the drum,

• the washing program is not appropriate,

• there is not enough detergent.

The machine is vibrating or noisy:

• not all the packing was removed from the machine (see unpac-

king section),

• the washing machine is not leveled and properly packed,

• the washing machine is too close to the wall or furniture,

• the washing is not well distributed in the drum,

• the load is not sufficient.

The washing cycle is much too long: • the water inlet is blocked,

• there was a power supply failure or the water was cut off,

• the motor temperature safety device tripped,

• the water inlet temperature is lower than normal,

The washing machine stops during a washing cycle: • the water or electricity supply is defective,

• a rinse hold was programmed.

The cover does not open during the cycle: • the cover cannot open until 1 to 2 minutes after the

washing machine has stopped.

Softener or Javel water flows

through the overflow orifice

when filling:

* depending on model.

• you did not put in the right amount,

• the siphons at the back of the detergent dispenser are

blocked.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zanussi ta 850 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info