Bedienungsanleitung Zanussi ZTE 170 (Seite 13 von 58) (Deutsch)

69302

Zoom out

Zoom in

Vorherige Seite

1/58

Nächste Seite

the machine is per-

forming the count-

down, after having

done so and having

closed the door, press

START/PAUSE

again, in order to

allow the machine to

complete the remain-

ing countdown time.

Indicator lights

These lights indicate

the following func-

tions:

• Drying light

This light indicates

that the appliance

is in the drying

phase.

• End of pro-

gramme light

This light is on at

the end of the

cooling phase,

during the anti-

creasing phase

and at the end of

the programme.

• Water reservoir

full light

This light indicates

that the appliance

is in the drying

phase.

This light comes

on at the end of

the programme to

remind you that

the water reser-

voir must be emp-

tied out. If this

light illuminates

during a pro-

gramme this

means that the

water reservoir is

full. The buzzer

sounds, the pro-

gramme stops,

the light of the

Start/Pause

button flashes.

This light comes

on also when the

water reservoir is

not inserted cor-

rectly.

• Filter cleaning

This light illumi-

nates at the end

of the programme

to remind you that

the filters must be

cleaned.

• Condenser

cleaning

It comes on every

80 cycles to

remind you that

the condenser

must be cleaned.

Cancelling a

programme

Turn the selector dial

to “O” to cancel a pro-

gramme which is run-

ning. Now you can

select a new pro-

gramme.

At the end of the

programme

If the laundry is not

removed at the end of

the cycle, the dryer

performs an anti-

creasing phase (dura-

tion: 30 minutes maxi-

mum).

If you do not remove

the laundry, the dryer

will stop automatically

at the end of the anti-

creasing phase.

Lights End/Anticrease

, and remain lit

and the buzzer

sounds for 2 minutes.

Turn the programme

selector dial to “O” to

switch the machine

off. Remove the laun-

dry from the drum and

carefully check that

the drum is empty.

If you do not intend to

carry out another

wash, close the water

tap. Leave the door

open to prevent the

formation of mildew

and unpleasant

smells.

Turn the programme

selector dial to “O”; all

the lights go out. The

appliance is switched

off.

Remove the laundry.

If you open and then

close the door before

turning the selector

dial to “O” all the

lights corresponding

to the phases making

up the performed pro-

gramme come on.

After each use

• Clean the filters.

• Empty the water

reservoir.

Important!

If the drying pro-

gramme has to be

stopped before it

reaches the end, we

recommend that you

turn the programme

selector dial to posi-

tion Cooling and

wait until the end of

this cooling phase

before removing the

laundry. This will

avoid a build-up of

heat inside the appli-

ance.To do this first

turn the dial to “O”

and then to Cooling

and depress Start but-

ton.

Modifying

the programme

To change a pro-

gramme which is run-

ning, first cancel it by

turning the pro-

gramme selector dial

to “O”. Select the new

programme and press

the Start button.

125987771 EN_1.qxp 2007-07-13 09:38 Page 13

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zanussi ZTE 170 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Zanussi ZTE 170

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info