15
Important:
Do not use the appliance without filters.
Cleaning the condenser unit
Clean the condenser when light comes on.
The condenser is situated at the lower part of the
cabinet behind a small door. To open the door,
push the catch as per picture.
During the drying cycle or at the end, it is normal
for water to be present on the surface of the
condenser insertion.
To pull out the condenser, first turn the two red
stops downwards and then remove the
condenser unit holding it at the handle.
Clean it with a brush and rinse it under the
shower if necessary. Also clean the outside,
removing all fluff.
Clean the rubber seal round the condenser cab-
inet and in the inner part of the small door with
a damp cloth.
Important:
Do not use pointed objects or utensils to clean
the spaces between the plates, as this could
damage the condenser and make it permeable.
Re-fit the condenser, turn the red stops upwards
and close the door.
Important:
Do not use this appliance if the condenser has
not been fitted.
Emptying the water reservoir
Water extracted from the laundry condenses
inside the machine and is collected in a reservoir.
The reservoir must be emptied after each drying
cycle to ensure efficient operation when the
machine is next used. The pilot light reminds
you this operation.
Proceed as follows:
• Open the small door at the lower part of the
cabinet
• Turn the yellow stop upwards
• Pull out the reservoir
• Open the small cover and let water flow
down
• Close the small cover and re-insert correctly
