Bedienungsanleitung Zelmer 04Z010 (Seite 44 von 46) (Englisch, Polnisch)

538910

Zoom out

Zoom in

Vorherige Seite

1/46

Nächste Seite

GW04-003_v03

The fryer complies with the requirements of the binding

norms.

The appliance complies with the requirements of the

directives:

Electrical low voltage appliance (LVD) – 2006/95/EC. –

Electromagnetic compatibility (EMC) – 2004/108/EC. –

The appliance is marked with an indication CE on the data

plate.

Parts Map (Fig. A)

Cover lid

Frying basket release button

Handle

“POWER” lamp

“TEMP.” lamp

Cover lid opening button

“Set” button – timer

Temperature control

Filter cover

Filter

Frying basket

Pot

Power supply cord storage compartment

Power supply cord and plug

Operation and use (Fig. B)

Put the appliance on a horizontal, even and stable

surface out of the reach of children.

Fill the fryer with oil, liquid fat or melted solid fat up to the

level between indication marks of MIN and MAX on the inner

part of the pot (12) based on gures presented in the below

table:

Capacity Liquid fat Solid fat

MIN

2.2 liters 1925 g

MAX

2.5 liters 2200 g

We advise you to use frying oil or other liquid fat. If you want

to use new blocks of fat, melt them slowly over a low heat

in a normal pan to prevent spattering or overheating of the

fat. It is possible to use solid fat, but in that case extra pre-

cautions are necessary to prevent the fat from spattering.

ATTENTION: Never mix two different kinds of oil or fat.

Close the lid (1) and put the plug in the wall socket.

The red “POWER” (4) indicator signalling connection of

the appliance to the electric power sup-ply becomes bright

simultaneously as well as the green “TEMP.” (5) indi-cator

signalling that the appliance is in heating up process.

Set the temperature control (8) to the correct temperature.

For informa-tion about which temperature to select, check

the chapter “Preparation times and temperature settings” in

this Use & Care Manual. The oil or fat will be heated to the

right temperature in 10 to 15 minutes.

While the fryer is working, the green indicator light (5) will go

on and off a number of times as a result of reaching the set

temperature. This is a normal state. When the appliance is

ready for frying (the set temperature has been reached), the

green indicator light will go off.

The same procedure applies if you want to fry a number of

batches in a row. Therefore, wait until the green indicator

light has gone off before you start frying the next batch.

Open the lid (1) pressing the release button (6).

Lift the handle (3) and the basket (11) will automatically

raise to its highest position.

Take the basket out of the fryer. Put the food to be fried

in the bas-ket. For the best frying results, we advise you to

use the recom-mended quantities of food as indicated in the

chapter “Preparation times and temperature settings” of this

Use & Care Manual.

ATTENTION: During frying, hot steamed is released

through the l-ter (10). Remember to keep your hands

and face at a safe distance from the lter. You should

also be careful of the hot steam when you open the

lid (1).

Carefully insert the basket (11) in the fryer and make

sure it is properly installed.

Next, close the lid (1).

Gently lift the handle (3), slide the release button (2) on

the basket handle (3) and carefully place the basket (11) in

the lowest position.

In order to set the required frying time (in minutes), press

the button „Set” (7) of a timer.

Method of using the timer button

Keep pressing the timer button

●

„Set” (7) for 1 second.

The display of the timer will show a gure <00>. The

display will turn off 5 seconds after the last pressing.

Keep pressing the button

●

„Set” (7) In order to set

the required time. The gure on the display increases

by 1 minute from <00> to <30>. When the time setting

reaches the Max. gure, further pressing of the button

„Set” (7) will again cause an increase of the gure

on the display from the beginning, i.e. from <00> to <30>

minutes.

2 seconds after setting the time, the display will begin to

●

ash and count down the time. During counting down the

dis-play show the gure indicating the remaining time of

frying. The last minute of frying is indicated in seconds.

Keeping pressing the button

●

„Set” (7) for over

2 seconds during counting down the time results in

stopping of counting down. The display will show a gure

<00>. Then, the timer may be set again. The display will

turn off and the appliance will switch over to stand-by

after about 5 seconds from the last pressing.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zelmer 04Z010 Seite 44

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info