539210

Zelmer AH1500 Seite 53

53
Zoom out
Zoom in
Vorherige Seite
1/54
Nächste Seite
57
AH1500-001_v01
Cleaning and maintenance
The humidier should be cleaned at least once
a week.
1
Before cleaning, turn off the appliance by pressing the
“ON/OFF” button and disconnect the plug from the wall
outlet.
2
Remove the water tank from the base of the humidier,
lifting it up with the handle. Turn the water tank upside down.
3
Loosen the cap with the valve by turning it counter
clockwise and drain the water remaining in the tank.
4
Remove the water softener lter (see “FITTING THE
WATER SOFTENER FILTER”).
Fill water tank with hot water and mild detergent
●
(dishwashing liquid), tightly screw the cap with the
valve and shake the tank several times. Empty the tank.
Repeat the operation several times by pouring water
into the tank without detergent until complete removal of
detergent residue.
Pay attention not to leave any cleaning solution
(detergent) in the water tank.
5
Empty the base of the humidier removing the
accumulated water (see section “DRAINING THE BASE OF
HUMIDIFIER”).
6
Gently clean the ultrasonic transducer, using the brush
supplied.
Regular cleaning reduces scaling.
PREVENTION AGAINST SCALE BUILD
Use cooled boiled water or distilled water. The water
●
temperature should not exceed 40°C.
At least once a week clean the water tank, humidier
●
base and ultrasonic transducer.
Before using the humidier, always pour fresh water into
●
the water tank.
If you do not use the humidier for a long time, empty the
●
water tank and humidier base, then wash all parts of the
humidier, wipe and dry it.
The appliance is best stored in its original packaging.
●
DESCALING THE AIR HUMIDIFIER
1
Turn the appliance off by pressing the “ON/OFF” button
and unplug the power cord from the wall outlet.
2
Fill the container with 50 ml of vinegar (6% solution of
acetic acid) and 100 ml of water, and mix the whole. Pour
the resulting solution into the base of the humidier for 30
minutes.
3
Empty the base of the humidier (see section “DRAINING
THE BASE OF HUMIDIFIER”) and remove the scale with
a soft cloth.
4
Rinse the base of humidier with clean water and dry it
with an absorbent cloth.
D
Be careful that no water gets into the fan outlet
(electrical components) because it may cause
serious damage to the humidier.
If water gets into the fan outlet, contact your
service center.
FITTING THE WATER SOFTENER FILTER
The air humidier is equipped with a water softener lter.
Special cartridges contained in the lter are installed to
prevent the growth of bacteria and also they react with the
calcium contained in the water, which protects the ultrasonic
transducer from scale.
1
Remove the steam jet from the water tank.
2
Remove the water tank from the base of the humidier,
lifting it up with the handle. Turn the water tank upside down.
3
Loosen the cap with the valve by turning it counter
clockwise.
The direction of unscrewing and screwing is
marked on the underside of the cap with the
valve.
4
Attach and tighten water softener lter on the thread
located on the cap with the valve.
5
Replace the cap with the valve with mounted water
softener lter to the water tank and turn the cap in a clockwise
direction until the water tank is sealed.
The direction of unscrewing and screwing is
marked on the underside of the cap with the
valve.
6
Turn the container upside down and mount the water
tank by putting it on the base of the humidier. Mount the
steam jet on the water tank.
Water softener lter should be replaced after
about 6 months of operation, in order to
achieve the best efciency of water softening.
CLEANING THE INLET FILTER
The main function of the inlet lter is to protect internal
components from excessive dirt.
Before you start cleaning the inlet lter, make
sure that the air humidier is turned off and the
plug is pulled out from the wall outlet.
Inlet lter should be cleaned periodically in
case of heavy pollution.
1
Remove the steam jet from the water tank.
2
Remove the water tank from the base of the humidier,
lifting it up with the handle. Turn the water tank upside down.
3
Empty the base of the humidier removing the
accumulated water (see section “DRAINING THE BASE OF
HUMIDIFIER”).
F
G
… 53

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Zelmer AH1500 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info