Bedienungsanleitung Zelmer CK2320 (Seite 51 von 54) (Englisch, Polnisch)

538885

Zoom out

Zoom in

Vorherige Seite

1/54

Nächste Seite

CK2320-001_v01

Cleaning the inside of the appliance

– descaling (Fig. I)

Before cleaning, make sure that the appliance is

unplugged and cool and there in no water in it.

Always follow the recommendations given

below to avoid scalding with hot water:

When pouring water, do not exceed the MAX ll

●

indicator (15).

When cleaning the appliance using citric acid, the lid

●

should be closed.

The cleaning process consists in boiling water. Be

●

careful as hot steam may cause scalding.

Follow the steps below to clean the appliance using citric

acid (it should be cleaned every 2-3 months).

Ret the lter (10) inside the appliance if it has been

removed.

Place 40 g of citric acid in the appliance.

Fill the appliance with water to the MAX level and close

the lid (3).

Plug the appliance and press and hold the

DECHLORINATE/RE-BOIL button (18) for 3 seconds.

The appliance will heat water and go to the cleaning

●

mode (the process will last approx. 1.5 hours). The

temperature LED indicators (24) will come on and go out

in the following order: 98°C – 85°C – 65°C.

After the end of the descaling process, you will hear

a sound signal three times.

The temperature LED indicators

●

(24) and the RE-BOIL

LED indicator (19) will come on and go out in the

following order: 98°C – 85°C – 65°C – – RE-BOIL.

After the cleaning process, unplug the appliance and

pour out the hot water.

If there are any deposits left in the appliance, wipe them

●

using a sponge and wash with water, and if this does not

help, repeat the entire process.

In order to get rid of the citric acid aftertaste, boil and

●

pour out water twice.

Cleaning the suction pump (Fig. J)

Mineral deposits forming in the suction pump may clog

the pump and cause water to ow out slower than usual.

Therefore, the suction pump should be cleaned every

6 months using citric acid, as follows:

Remove the lter (10) from the inside of the appliance.

Dissolve approx. 30 g of citric acid in approx. 200 ml of water.

Pour the mixture into the hole at the bottom of the appliance.

Fill the appliance with water up to 1/3 of its capacity.

Close the lid and plug in the appliance (select the keep-warm

function at 85°C).

Keep the temperature 85°C for 2 to 3 hours.

●

Press the lock button

●

(21) ( / ), to unlock the

appliance. The lock LED indicator (22) will come on.

Press the (20) DISPENSE button and pour out the water.

Unplug the appliance from the mains.

Pour out the remaining water.

Allow the appliance to cool completely and ret the lter.

●

In order to get rid of the citric acid aftertaste, boil and

●

pour out water twice.

Citric acid may be purchased from a pharmacy

or supermarket.

Citric acid is a food additive and it is harmless

to human health.

Notes on cleaning and storing the appliance

Never wash the appliance under running water and ll

●

it with water directly from the tap, because it may cause

a short-circuit or electric shock.

Never wash the appliance under running water, as water

●

may get into its internal parts and cause damage.

Never use any detergents, cleaners, scourers, nylon

●

brushes, articial cloths or bleaches for cleaning the

casing.

Never wash the appliance in a dishwasher or dry it in

●

automatic dryers, as this may cause damage to the

appliance.

Various black-coloured, rust-like, milk-like, etc. deposits

●

(including oating ones) may form inside the appliance.

They are caused by minerals which occur naturally in water

(calcium, magnesium, iron, etc.). Such discolorations are

not caused by faulty operation of the appliance and do not

affect its use. In case of greater accumulation of mineral

deposits, proceed as described in section (I).

Remove the lter before cleaning the inside of the appliance

●

(10). Clean the lter under running water using a sponge or

brush. Water ow may be blocked if the lter is clogged with

lime scale. Remember to replace the lter after cleaning.

Stains which are difcult to remove with a sponge should

●

be cleaned with citric acid or vinegar.

Failure to clean the inside of the appliance on a regular

●

basis may increase the noise during operation, making it

impossible to remove all mineral deposits in the future or

causing malfunction.

Using mineral or alkaline drinking water will result in

●

greater accumulation of mineral deposits inside the

appliance and may cause obstruction of the dispensing

spout (11) and the steam outlet (2). It is necessary to

descale the appliance regularly.

Discolorations due to overheating cannot be removed.

●

If you do not intend to use the appliance for a long period of

●

time, descale the lid and the inside of the appliance, clean

the outside surfaces with a soft cloth with mild detergent

and allow to dry (this is particularly important for the inside

of your appliance). It is best to place the appliance in

a plastic bag to protect it against dust and insects.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zelmer CK2320 Seite 51

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info