Playing an Audio CD
To play an audio CD inserted in the CD-R/RW drive,
proceed as follows. This method can also be used to
audition a CD-R/CD-RW disc to which audio data was
written.
A non-finalized CD-R/CD-RW disc cannot be played by any
other method.
Verify that the CD-R/RW drive is connected to
the SIB-01 and turned on.
1.
Verify that a suitable disc is inserted in the CD-
R/RW drive.
2.
In the main screen, press the [PROJECT/UTILITY]
key.
3.
Use the cursor [
E
]/[
R
] keys to make the display
indicate "UTILITY CD-R/RW", and then press the
[ENTER] key.
If the above menu does not appear, the MRS-
1044 has not properly recognized the CD-R/RW
drive. Check the power on/off condition of the
drive and the SCSI connection.
4.
Use the cursor [
E
]/[
R
] keys to make the display
indicate "CD-R/RW PLAYER", and then press the
[ENTER] key.
The display indicates the following information.
(1)Track number
Indicates the number of the track on the audio CD or CD-
R/CD-RW disc.
(2)Playback method
Indicates the currently selected audio CD playback
method. "D" stands for digital playback and "A" for analog
playback.
(3)Finalize status
When a "*" symbol is shown here, a non-finalized CD-
R/CD-RW disc is inserted.
(4)Current location
The location in the current track is shown here in hours
(H), minutes (M), and seconds (S).
5.
Use the FF [
Y
] key and REW [
T
] key to select the
track to be played.
While the above indication is shown, the FF [Y] and REW
[
T] keys can be used to select the track on the CD.
The FF [
Y] key selects the next track and the REW [T]
key selects the previous track.
6.
Use the cursor [
W
]/[
Q
] keys to select the playback
method (MRS-1044 only).
On the MRS-1044, each push of the cursor
[
W]/[Q] keys toggles between the following
two methods.
●
D (Digital playback)
The digital audio signal of the CD is read into the MRS-
1044 and becomes available at the rear panel [OUTPUT]
jacks (DIGITAL, PHONES, MASTER L/R). (Default
setting)
●
A (Analog playback)
The audio signal of the CD is reproduced via the
headphone and line outputs of the CD-R/RW drive.
On the MRS-1044CD, only digital playback is
possible. Note that the CD playback output will
be cut off if you select "A" (analog playback).
7.
To control CD playback/stop, use the transport
section keys of the MRS-1044 series.
While the above indication is shown, the transport section
keys of the MRS-1044 series operate as follows.
●
PLAY [
R
] key
Playback of the selected track starts. Pressing the key
during analog playback sets the system to pause mode.
