was
now
Whenever you change one of the PK-232's parameters, both the previous
value and the new value are displayed.
bbRAM scanned, checksum failed!
This message indicates there has been an error in the battery backed
RAM. A low lithium battery is the likely cause for this.
ERROR: Subroutine, Bank, Addr
This message indicates a program error has occurred. Write down any
information accompanying this message and call AEA's Technical Support
department. If possible, print a DISPLAY Z parameter listing.
ROM error, checksum $xxxx
This message indicates there has been a failure in the PK-232. If
this message appears, call AEA's Technical Support department.
A.4.2 General Error Messages
An error message is displayed if the PK-232 does not understand what
you typed, or needs more information. If you see an Error message,
look up the Command to make sure you are entering it properly.
?What?
Your first entry is not a command or a command abbreviation - your
PK-232 did not understand your instructions!
?bad
You typed a command name correctly, but the remainder of the command
line was not understood.
?callsign
You typed a call sign that does not meet the PK-232's requirements.
?clock not set
You typed the command DAYTIME, but you haven't yet set the clock!
?not enough
You didn't type enough arguments for a command that needs several.
?range
You typed a numeric argument too large or too small for that command.
?too many
You typed too many arguments for the command to accept.
4/91 A-4
