?too long
You typed a command line that is too long. For example, if you type a
BTEXT or CTEXT message that is too long you'll receive this message.
?need ALL/NONE/YES/NO
This message indicates you have forgotten the ALL, NONE, YES or NO
parameter in the CFROM, DFROM or MFROM commands.
*** Transmit data remaining
If the PK-232 is commanded back to receive with the RCVE command when
it still has data in the transmit buffer waiting to be sent.
not while in (MODE)
This message will appear any time you try to do something that is not
permitted in the current PK-232 operating mode.
Serial port configuration will change on next RESTART
This message means you have changed the terminal baud rate TBAUD,
word-length AWLEN or the PARITY. When you type the RESTART command,
the new baud rate will take affect.
?need MYSelcal or ?need MYIdent
This message will appear if you try to communicate with another AMTOR
station before you have entered a valid SELCALL (MYSELCAL) or MYIDENT.
?not enough memory available
This message appears if you try to change to FAX when the MailDrop is
too full.
A.4.3 Packet Error Messages
In addition to the General Error Messages described above, the
following messages may appear when entering Packet related commands.
?need MYcall
This message appears if you attempt to make a packet Connection but
have not yet entered your callsign in MYCALL.
?not while connected
You attempted to change MYCALL or AX25L2V2 while in a connected state.
?not while disconnected
You tried to set CONPERM while disconnected.
LINK OUT OF ORDER, possible data loss
You are CONPERMed to another packet station but the link has failed.
4/91 A-5
