626264
11
Zoom out
Zoom in
Vorherige Seite
1/16
Nächste Seite
GB
CONNECTION TO HOT WATER 4.
HEATER
(Applies only if a water heater 2959 is tted)
In order for the water heater to work, it must be con-
nected to the fresh water system. From the heater, the
hot water hose should run to the shower, thermostat
mixer, sink, etc. On the water heater, connections
1/4"R should be used. P.T.F.E. tape or similar should
be used a thread of connections to avoid leakage.
The fresh water connections are located on the rear of
the heater. Incoming water at the bottom and outgoing
water at the top. So that the fresh water can be easily
drained off when the heater is not in use, a drain cock
should be tted to the incoming connection and an air
screw on the outgoing connection.
Fig 15
Air screwA.
Hot waterB.
Water heaterC.
Cold waterD.
Drain cockE.
INSTALLATION INSPECTION5.
The LP gas system:
After installation or service, always test the LP gas
installation under pressure following currently valid
regulations.
If a leak is present, nd the leak using leak detection
spray or soapy water. Note: open ames must not
be used during leak localisation.
Check that the reduction valve is at the right
pressure.
We recommend the mounting of an Alde LP gas leak-
age tester in order to further increase safety. The tester
is mounted closest to the reducing valve and enables
you to test that the system does not leak by simply
pushing a button.
The heating system:
The heating system should be tested for leaks when
the complete system is visible, that is, before any
ttings are mounted. Two methods are possible:
either test pressurisation at 0.75 - 1.0 bar for 15 min
utes, followed by reduction of the pressure to a maxi
mum of 0.05 bar; or by lling the system with liquid
and checking by inspection. No leakage of liquid can
be accepted.
Check that all hose clips are tted and correctly
placed.
Other points:
Check that the drainage tubes and the bleed tube on
the expansion tank are not blocked, and check that
the drainage tap on the water heater (if mounted) is
not blocked.
Check that the circulation pump rotates in the correct
direction (anticlockwise) at the rubber connection.
Check that the chimney and the chimney pipe are
correctly placed and securely attached, and check
that the input tube on the Comfort 2928 is mounted
on both chimney and boiler.
Check that air can pass freely through the ventilation
drum.
11
11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Alde Comfort 2928 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Alde Comfort 2928

Alde Comfort 2928 Bedienungsanleitung - Deutsch, Englisch, Holländisch, Französisch, Schwedisch, Finnisch - 32 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info