Bedienungsanleitung Arcam DiVA AVR280 (Seite 11 von 38) (Englisch)

578769

Zoom out

Zoom in

Vorherige Seite

1/38

Nächste Seite

AVR280

English

Control connections

(REMOTE) OUT. This outputs any remote control signal that is received by one of the two remote

control inputs described below (but not signals received from the front-panel). It allows remote

control of source components; control is possible by either connecting this output to the devices to

be controlled via the 3.5mm IR jack socket (Arcam units only) or by using an IR emitter stuck to the

centre of the IR sensor window on the source component (such as a Xantech 283MW mini emitter).

IN LOCAL. Use with a local IR receiver when the AVR280 front panel IR receiver is obstructed.

IN ZONE 2. This allows the AVR280 to be controlled remotely from Zone 2 via infrared remote

control (see section ‘Zone 2 connections’ above for further details).

RS232 CONTROL Use with control devices having an RS232 serial port (for example, Crestron and

AMX touch screen controllers). This connection is also used for upgrading control software. See the

sections at the end of this manual for control and programming information.

Trigger outputs

There are three trigger output sockets on the AVR280, each of which is a 3.5mm stereo jack with two

contacts, ‘tip’ and ‘ring’. See the tables for technical information on the trigger outputs.

12V TRIGGER. This can be used for turning on and off automatically

power amps or source equipment for the main zone and Zone 2. The trigger

lead is wired as shown in the panel.

VIDEO TRIGGER 1,

VIDEO TRIGGER 2. These trigger outputs have

different functions depending on how the ‘Video Status’ has been set in the

‘General Settings’ menu. See page 10 for full details.

Connecting to a power supply

POWER INLET. The AVR280 has a dual voltage power supply that can be switched between 120V

and 230V AC. As supplied, this switch should be set correctly for your local supply.

GROUND LIFT switch. In complex set-ups that include satellite inputs or radio antennas, grounding

the unit may increase the level of background hum or buzz in the loudspeakers. If this occurs, set the

GROUND LIFT switch to lift the signal ground from the chassis ground.

DO NOT REMOVE the safety earth from the mains cable under any circumstances.

Mains lead

The appliance is normally supplied with a moulded mains plug already tted to the lead. Check that the

plug supplied with the unit ts your supply. If your mains plug is different, consult your Arcam dealer.

If for any reason the plug needs to be removed, it must be disposed of immediately and securely, as it

is a potential shock hazard when inserted into the mains socket. Should you require a new mains lead,

contact your Arcam dealer.

Plugging in

Push the plug (IEC line socket) of the power cable supplied with the unit into the power input socket

(

) in the back of the unit. Make sure it is pushed in rmly.

Put the plug on the other end of the cable into your power supply socket and switch the socket on.



















 







  

  

Connection Function Voltage

Tip Main zone on On = 12V, 30mA

Off = 0V

Ring Zone 2 on On = 12V, 30mA

Off = 0V

Sleeve Ground 0V

















Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Arcam DiVA AVR280 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info