Bedienungsanleitung Arcam solo movie 2 1 (Seite 20 von 30) (Englisch)

160350

Zoom out

Zoom in

Vorherige Seite

1/30

Nächste Seite

E-20

Speaker set-up

This menu screen allows you to specify the speaker

conﬁguration that is connected to the analogue outputs of

your Solo Movie 2.1. It is important that this conﬁguration

reﬂects accurately the actual situation, otherwise audio

quality may be severely compromised.

The speakers are conﬁgured as follows:

Front Left/Right

‘Large’, or full-range speakers can accept audio with the

full frequency range of the source material. With the

Front Left/Right speakers set to ‘Small’, mid- to high-range

speakers will receive a reduced frequency range, with low

frequency information re-routed to the subwoofer. Make

sure that a subwoofer is present if you have set Front

Left/Right speakers to ‘Small’!

Large Front speakers set to ‘Large’ – audio sent with

the full frequency range present

Small Front speakers set to ‘Small’ – audio sent with a

reduced frequency range. This setting requires an

active subwoofer to be present.

Subwoofer

This setting indicates if an active subwoofer is present. If

it is available, low frequency information is routed to the

active device.

None No active subwoofer is connected

Present An active subwoofer is connected

Sub with stereo

This setting controls whether the low frequency

information is redirected to the subwoofer, or not. This

item can be changed only if a subwoofer is speciﬁed as

present in the system and speakers are set to ‘Large’.

Off No redirection of low-frequency information

occurs; all the audio is sent to the Front

speakers.

Bass

redirected

Low-frequency information is redirected to the

subwoofer, with the remaining (higher-frequency)

information sent to the Front speakers.

Bass

duplicated

All the audio is sent to the Front speakers.

In addition, the low-frequency information is

duplicated to the subwoofer.

Crossover frequency (Hz)

This setting deﬁnes the frequency at which bass-

redirection begins. Frequencies below this level are

redirected from ‘small’ speakers to the subwoofer;

frequencies above this level are not redirected. The

redirection frequency is the same for all the speakers in

a system.

The optimum crossover frequency depends on the

characteristics of your speaker set-up, and is best

determined by experimentation. The setting ranges from

40Hz to 150Hz: we suggest you start at 100Hz.

Trims

Trims for the Subwoofer (and Sub with stereo, if enabled)

can be set in within the range of -10dB to +10dB using

the associated sliders. Adjustment is in steps of 1dB, with

a default of 0dB.

These settings are useful if the speakers have different

sensitivities (and so have different volumes for the same

input levels).

Subwoofer/Sub with stereo trims

Both the ‘Subwoofer’ and the ‘Sub with stereo’ trims

control the subwoofer trim setting. ‘Subwoofer’ is the trim

used when multi-channel material is being played; ‘Sub

with stereo’ is the subwoofer trim used with two-channel

material.

Although Solo Movie 2.1 is very ﬂexible in the

speaker conﬁgurations it can handle, some restrictions

have been applied. For example, if no subwoofer

is present, then it is not possible to conﬁgure the

speakers to be ‘Small’ since there would be nowhere to

redirect the low frequency information.

If no subwoofer is present, Solo Movie 2.1

automatically turns on Audio compression to prevent

digital clipping in the signal processing.

Completing the set-up

Complete the set-up procedure by pressing SETUP on the

remote control (in DVD mode). This saves all the data and

closes the set-up menus. You can press SETUP at any time

while in a menu to quit from it.

To return to the set-up menus at any time, press the

SETUP button (again, in DVD mode).

Arcam Muso/Logo speakers

When using two Arcam Muso as Front Left/Right

speakers with an Arcam Logo subwoofer – set Front

Left/Right to ‘Small’ and Subwoofer to ‘Present’.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Arcam solo movie 2 1 Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Arcam solo movie 2 1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info