Bedienungsanleitung Ariston Piccolo (Seite 29 von 96) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Polnisch)

719969

Zoom out

Zoom in

Vorherige Seite

1/96

Nächste Seite

The use of multiplugs, extensions or adaptors is strictly prohibited.

It is strictly forbidden to use the piping from the plumbing, heating and gas systems for the appliance earthing

connection.

The appliance is not protected against the effects caused by lightning.

Before turning the appliance on, make sure the supply voltage complies with the value stated on the appliance data

plate and that the appliance itself is filled with water.

If the appliance is not supplied with a power supply cable, make a fixed connection to the mains using a rigid pipe or

cable for permanent installation.

The following operations should be performed annually:

- empty the appliance and dismount the heating element;

- carefully remove all limescale from the heating element parts; if you prefer not to use acids designed especially for

this purpose, use non-metallic objects to break off the limescale crust that has formed, taking care not to damage

the heating element’s armour.

- We recommend you replace the seal each time you dismount the heating element.

The temperature of the water can be selected on the knob (F fig. 6) and can be adjusted from 40 to 80°C approximately.

We recommend you set the temperature of the water heater to 60°C to:

- reduce the formation of limescale;

- reduce heat dispersion;

- avoid the risk of bacteria proliferation.

Starting and testing the appliance

Adjusting the operating temperature

MAINTENANCE REGULATIONS (for competent persons)

WARNING! Follow the general warnings and the safety norms listed at the

beginning of the text and keep to all the instructions given under all circumstances.

Anti-freeze function

Replacing parts, when necessary

Periodic maintenance

If the temperatures in the room where the appliance is installed can reach particularly low values, set the knob (F fig.

6) to setting *.

The pilot lamp (A fig. 4) stays on during the heating phase.

Before powering the appliance, fill the tank up with mains water.

Set the knob (F fig. 6) to the desired position, plug the appliance into the socket or switch the main switch to “ON”.

Check the appliance operation until the end of the first heating cycle, indicated by the relative pilot lamp turning off.

During the heating phase, the water expansion could cause some trickling from the tap: this is completely normal and

does not mean the tap is faulty. Do not screw the taps too tightly to prevent damaging their seals.

In the event of a malfunction, read the paragraph regarding the MAINTENANCE REGULATIONS.

All maintenance operations and service visits should be performed by a competent person (who have the

skills required by the applicable norms in force).

Before performing any maintenance operations and/or replacing any components, disconnect the appliance

from the electricity mains using the external switch; empty out the water heater if necessary.

See warning nos. 20 - 26 - 28

To access the electrical parts (heating element, thermostat, pilot lamp), remove the cover C by unscrewing screws D

(fig. 4).

In the event of an intervention on the thermostat, disconnect the latter from the electricity mains and slide it out of its

seat on the heating element. In the event of an intervention on the heating element, unscrew the bolts (A fig. 6) using

a 10 mm spanner.

When remounting the components, make sure you put the flange seal, the thermostat, the heating element and all

pipes back in their original position.

We recommend you replace the seal each time you dismount the flange.

Once the aforementioned operations are complete, make sure you fill the appliance with water before powering

it.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ariston Piccolo Seite 29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info