Bedienungsanleitung AS Motor AS 940 Sherpa 4 WD RC (Seite 44 von 60) (Englisch)

736695

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

Maintenance

Maintaining the engine

Caution

If the speed is set too high, objects can be ejected. The

engine can be damaged and a higher level of noise pollu-

tion is produced.

► Do not change the basic setting of the carburetor or the

speed control.

The engine manufacturer has prepared the operating manual

of the engine. The manual contains all maintenance require-

ments and warranty conditions for the engine. If warranty

work on the engine is required, contact your authorised ser-

vice centre or the next authorised dealer for engines.

To ensure a long service life of the engine, sufficient engine

cooling is required.

Keep the

- engine cover (ventilation grid),

- silencer (protective grid) and

- cooling fins of the engine

clean at all times.

Opening the engine cover

Warning

The engine cover can accidentally close.

► Make sure that the engine cover stays open while you

carry out work on the engine. Close the engine cover

immediately after you have completed maintenance

work on the engine.

Warning

Burn hazard from hot surfaces.

► Let the device cool down for at least 20minutes before

you open the engine cover.

To carry out maintenance work on the engine, slacken the

screws(1) and open up the engine cover.

Checking the engine oil level

Never allow the oil level to be too low otherwise the engine

can be damaged. Never fill in too much oil. Otherwise, there

is the risk that the oil enters and destroys the air filter.

For this, observe the attached operating instructions of the

engine.

Checking the spark plug

Danger

The ignition system generates an electromagnetic field.

► Wearers of pacemakers must not work on live parts.

Soiled spark plugs reduce the engine output. Clean the elec-

trode of the spark plug with a brass wire brush. Check the

electrode gap (see operating instructions of the engine manu-

facturer). Make sure that the insulator around the electrode is

not damaged. Never use a damaged spark plug.

Tighten the spark plug using the correct torque (see operat-

ing instructions of the engine manufacturer).

Always check both spark plugs.

Maintaining the air filter

Warning

There is a fire and explosion risk due to cleaning agents.

► Never clean the air filter with flammable solvents.

Make sure that the air filter is always clean. A dirty air filter

reduces the engine power and leads to increased engine

wear and fuel consumption. Independent of the operating

hours, change the filter insert at least once a year. Do not op-

erate the engine without air filter.

For this, observe the attached operating instructions of the

engine.

Checking and charging the battery

Warning

Batteries can be dangerous.

► Keep children away.

► Never perform any changes to the battery.

► The battery is sealed and may never be opened.

► For all work on the battery or the battery cables, wear

safety glasses and gloves.

► If accidents with battery acid occur, always contact a

doctor.

Warning

Explosion hazard

When the battery is charged, explosive gases are gener-

ated. An explosion of the battery can result in injuries and

blindness.

► Keep open flames and ignition sources away and do not

smoke.

► Charge the battery only in well ventilated rooms.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

AS Motor AS 940 Sherpa 4 WD RC Seite 44

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von AS Motor AS 940 Sherpa 4 WD RC

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info