680440
36
Zoom out
Zoom in
Vorherige Seite
1/144
Nächste Seite
5.11 DIL switch14
Impulse behaviour during the hold-open phase:
The impulse behaviour during the hold-open phase can be set
for operation with automatic timed closing.
14 ON An impulse cancels the hold-open phase.
Theoperator closes the gate after the
pre-warning phase has elapsed.
14 OFF
An impulse increases the hold-open phase by the
pre-set time.
5.12 DIL switch15
Setting the speed:
See Figure9.2 and section4.3.2
15 ON Slow mode (slow speed); (no SKS required)
15 OFF
Normal mode (normal speed)
5.13 DIL switch16
Setting the operating mode:
Press-and-hold operation can be set with DIL switch16.
Theforce limit is set to the maximum value.
16 ON Press-and-hold operation
• A permanent contact at terminals20+ 21
moves the operator in the OPEN direction
• A permanent contact at terminals20+ 23
moves the operator in the CLOSE direction
• The operator stops if the respective contact
is interrupted
16 OFF
Normal mode
NOTE:
Special functions are possible during press-and-hold
operation in conjunction with a universal adapter print UAP1.
6 Radio
CAUTION
Danger of injuries due to unintended gate travel
Unwanted gate travel may occur while teaching in the radio
system.
Pay attention that no persons or objects are in the
gate's travel range when teaching in the radio system.
• After teaching-in or extending the radio system, perform
a function check.
• Only use original components when extending the radio
system.
• Local conditions may affect the range of the radio
system. Moreover, when used at the same time,
GSM900 mobile phones can affect the range.
6.1 Hand transmitter BDS140
WARNING
Danger of injury due to unwanted
gate travel
Pressing a button on the hand
transmitter may result in unwanted gate
cycles and cause injury.
Make sure that the hand
transmitters are kept away from
children and can only be used by
people who have been instructed
on how the remote-control gate
functions!
If the gate has only one safety
feature, only operate the hand
transmitter if you are within sight of
the gate!
Only drive or pass through remote-
control gate systems when the gate
is at a standstill!
Please note that unwanted gate
cycles may occur if a hand
transmitter button is accidentally
pressed (e.g. if stored in a
pocket / handbag).
ATTENTION
Functional disturbances caused by environmental
conditions
These conditions can impair function!
Protect the hand transmitter from the following conditions:
• Direct sunlight (perm. ambient temperature:
20°C to + 60°C)
• Moisture
• Dust
6.1.1 Description of the hand transmitter BDS140
See Figure10
1 LED
2 Hand transmitter buttons
3 Battery compartment cover
4 Battery
6.1.2 Inserting / changing the battery
See Figure10
Use only the battery type AAA (LR03) 1,5 V.
6.1.3 Excerpt from the declaration of conformity
Conformity of the abovementioned product with the
requirements of the directives according to article3 of the
R&TTE directives 1999 / 5 / EC was verified by compliance
with the following standards:
• EN 300 220-1
• EN 300 220-3
• EN 301 489-1
• EN 300 489-3
The original declaration of conformity can be requested from
the manufacturer.
36
C300 - C800 / Rev. 1.1 RE / 07.2014
ENGLISH
36

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Berner C500 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info