Bedienungsanleitung Black Decker CLMA4820L2 (Seite 14 von 144) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

709483

Zoom out

Zoom in

Vorherige Seite

1/144

Nächste Seite

ENGLISH

(Original instructions)

u Holding onto the handle, open, but do not remove, the

lower-handle attachment levers (6) and fold the handle to

the front of the mower as shown in gure S.

u Open, but do not remove, the upper-handle attachment

levers (5) and fold the upper handle (3) back over the

lower handle (4) as shown in gure T.

u The mower shold be compacted down as shown in

gure U.

Carrying the mower

u The mower can be carried using the convenient carry

handles (12) as shown in gure V. DO NOT attempt to

lift the mower by grasping the upper handle (3) or lower

handle (4).

Mowing tips

Warning! Always inspect area where mower is to be used

and remove all stones, sticks, wire, bones, and other debris

which might be thrown by the rotating blade.

Warning! Mow across the face of slopes, never up-and-down.

Exercise extreme caution when changing direction on slopes.

Do not mow excessively steep slopes. Always maintain good

footing.

u Release bail handle to turn mower “Off” when crossing

any gravel area (stones can be thrown by the blade).

u Set mower at highest cutting height when mowing in rough

ground or in tall weeds. Removing too much grass at one

time can cause the motor to be overloaded and to stop.

Refer to troubleshooting guide.

u If a grass collection bag (8) is used during the fast growing

season, the grass may tend to clog up at the discharge

opening. Release bail handle to turn mower off and

remove the safety key. Remove the catcher and shake

the grass down to the back end of the bag. Also clean

out any grass or debris which may be packed around the

discharge opening. Replace the grass catcher.

u If mower should start to vibrate abnormally, release bail

handle to turn mower off and remove safety key. Check

immediately for cause. Vibration is a warning of trouble.

Do not operate mower until a service check has been

made. Refer to troubleshooting guide in manual.

u Always release bail handle to turn mower off and remove

safety key when leaving it unattended even for a short

period of time.

Tips for optimum use:

u Slow down in areas where the grass is especially long or

thick.

u Avoid mowing when the grass is wet from rain or dew-

soaked.

u Cut your lawn frequently, especially during high growth

periods.

Note: It is recommended that your mower be recharged after

use to prolong the battery life. Frequent charging will not

harm your battery, and will ensure that the battery is fully

charged and ready for its next use. Storing battery not fully

charged will shorten battery life.

Removing and installing blade

Warning! When reassembling the blade system, ensure each

part is reinstalled correctly, as described below.

Improper assembly of the blade or other parts of the blade

system may cause serious injury.

Warning! Release bail handle to turn mower off, wait for the

blade to stop, and remove safety key and battery pack.

u Cut a piece of 2x4 wood (31) (about 2 feet long) (610 mm)

to keep blade from turning while removing bolt (32).

u Wear gloves and proper eye protection.

u Turn the mower on its side. Be careful of sharp edges of

blade. Position wood and unscrew bolt with 1/2” wrench

(33) as shown in gure W.

u Remove bolt and washer (34). pull off blade (35) as shown

in gure X. The fan (36) should not be removed. Examine

all pieces for damage and replace if necessary.

u The blade can only be attached to the fan in one direction.

To reassemble, line up the d-shaped hole of the blade with

the d-shaped post of the fan, ensuring the writing on the

blade faces out away from the mower.

u To tighten rmly, position the piece of wood as shown

in gure Y to keep the blade from turning. Slide the bolt

through the washer and screw bolt into place. Tighten with

the wrench.

Blade sharpening

Keep blade sharp for best mower performance. A dull blade

does not cut grass cleanly. Use proper eye protection while

removing, sharpening, and installing blade. Ensure that safety

key and battery pack is removed.

Sharpening the blade twice during a mowing season is usually

sufcient under normal circumstances. Sand causes the

blade to dull quickly. If your lawn has sandy soil, more frequent

sharpening may be required.

Note: Replace bent or damaged blade immediately.

When sharpening the blade:

u Make sure blade remains balanced.

u Sharpen blade at the original cutting angle.

u Sharpen cutting edges on both ends of blade, removing

equal amounts of material from both ends.

To sharpen blade in a vise (g. Z)

u Be sure the bail handle is released, the blade has stopped

and safety key and battery pack removed before removing

the blade.

u Remove blade from mower. See instructions for removing

and installing blade.

u Secure blade (35) in a vise (38).

u Wear proper eye protection and gloves and be careful not

to cut yourself. Carefully le the cutting edges of the blade

with a ne tooth le (39) or sharpening stone, maintaining

the angle of the original cutting edge. Check balance of

blade. See instructions for blade balancing. Replace blade

on mower and tighten securely.

Blade balancing (g. Z1)

Check balance of the blade (35) by placing centre hole in the

blade over a nail or round shank screwdriver (40), clamped

horizontally in a vise (38). if either end of the blade rotates

downward, le along the sharp edge of that dropping end.

Blade is properly balanced when neither end drops.

Lubrication

No lubrication is necessary. Do not oil the wheels. They have

Black Decker CLMA4820L2 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info