Bedienungsanleitung Black Decker GKC1825L20 T1 (Seite 11 von 16) (Englisch)

585836

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

ENGLISH

(Original instructions)

u To charge the battery (12), insert it into the charger (19).

not force. Be sure that the battery is fully seated in the

charger.

u Plug in the charger and switch on at the mains.

The charging indicator (18) will blink.

The charge is complete when the charging indicator (18)

switches to continuously on. The charger and the battery

switch on as the charger occasionally tops up the battery

charge.

u Charge discharged batteries within 1 week. Battery life will

be greatly diminished if stored in a discharged state.

Leaving the battery in the charger

The charger and battery pack can be left connected with the

the battery pack fresh and fully charged.

Charger diagnostics

If the charger detects a weak or damaged battery, the charg-

follows:

u Re-insert the battery (12).

rate, use a different battery to determine if the charging

process works properly.

u If the replaced battery charges correctly, the original

battery is defective and should be returned to a service

centre for recycling.

u If the new battery gives the same indication as the original

battery, take the charger to be tested at an authorised

services centre.

Note: It may take as long as 30 minutes to determine that

the battery is defective. If the battery is too hot or too

cold, the charging indicator will alternately blink red, fast

recommended chain oil. You can see the oil level in the oil

u Periodically switch off and check the oil level indicator

(11); if it is less than a quarter full, remove the battery from

Oiling the chain

We recommend that you use only Black & Decker oil

(A6027-50)during the lifetime of your chainsaw because

mixtures of different oils could lead to the oil becoming

degraded, which can drastically shorten the lifetime of the saw

chain and create additional risks.

Never use waste oil, thick oil or very thin sewing machine oil.

These may damage your chainsaw.

The saw chain (6) must be oiled before each use and after

cleaning using only the correct grade of oil (cat. no. A6023-

QZ).

u Lubricate the saw chain (6) by slowly pressing the bulb

each cut. Hold the bulb down for 1 second each time.

u f

button (2) with your thumb and then push the on/off switch

(1) to start.

u When the motor starts, remove your thumb from the lock-

Do not force the tool, allow the tool to do the work. It will do

a better and safer job at the speed for which it is designed.

Excessive force will stretch the saw chain (6).

If the saw chain (6) or guide bar (7) becomes

jammed

u Switch the tool off.

u Remove the battery (12).

u Open the cut with wedges to relieve the strain on the

guide bar (7). Do not try to wrench the chainsaw free.

u Start a fresh cut.

It is normal for a small amount of excess oil drip from the

chain saw bar and chain during storage. Do not store chain

saw on top of any thing that may be damaged by the dripping

oil.

tool. Slide the battery into the receptacle and push until

the battery snaps into place.

u To remove the battery, push the release buttons (16) while

at the same time pulling the battery out of the receptacle.

Use

Warning! Let the tool work at its own pace. Do not overload.

done before. The battery may become warm while charging;

this is normal and does not indicate a problem.

Warning! Do not charge the battery at ambient temperatures

below 10 °C or above 40 °C. Recommended charging tem-

perature: approx. 24 °C.

Note: The charger will not charge a battery if the cell

temperature is below approximately 10 °C or above 40 °C.

The battery should be left in the charger and the charger

will begin to charge automatically when the cell tempera-

ture warms up or cools down.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker GKC1825L20 T1 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Black Decker GKC1825L20 T1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info