Bedienungsanleitung Black Decker GL340 (Seite 12 von 16) (Englisch)

527583

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

or solvent which might contain chemicals that

could seriously damage the plastic. Do not spray

your trimmer with water.

• Self lubricating bearings are used in this tool and

so lubrication is not required.

Fault finding

Before checking your trimmer for any faults,

disconnect it from the mains.

• If your trimmer will not start, check that the

power cord is properly connected. If this does

not work, check your power point. Finally,

check the fuse and wiring on the cable extension

plug (UK only).

• If the automatic line feed fails to operate, it could

be for one of the following reasons:

Line too short or line jammed on spool

• Disconnect your trimmer from the power

supply.

• Remove the spool cover (8) by pushing both

tabs (12) inwards and upwards (Fig. F).

• Lift the spool (15) approximately 6mm (

/4")

from the spool housing (13), while pulling the

cutting line (5). This will allow you to lengthen

the line while clearing any line jammed inside

the spool. Ensure there is a minimum of 9cm

(3.5") protruding from the spool housing.

• Rotate the spool as necessary to fully seat

the spool and replace the cover by aligning

both tabs on the cover with the slots in the

spool housing and push into place. Ensure

that both tabs are securely located.

Line still jammed on spool or broken inside

spool housing

• Disconnect the power supply and remove

the cover, as previously described.

• Lift out the spool (15) completely, holding the

coiled cutting line in place to prevent it

unravelling from the spool (Fig. J).

• Carefully unwind the cutting line (5) from the

spool until any crossed or trapped loops are

cleared. Rewind the cutting line evenly, in the

direction of the arrow (16) on the spool.

• Temporarily park the cutting line end in one

of the ‘L’ shaped slots to prevent the spool

unravelling. Ensure you leave a minimum of

9cm (3.5") protruding.

• Turn the lever (18) backwards and forwards

to ensure it operates freely (Fig. K).

• Remove any dirt or grass that may have

collected inside the spool housing and cover.

• Feed the end of the line through the eyelet

(14) and then push the spool into the centre

drive shaft while pulling the free end of the

line to release it from the ‘L’ shaped slot.

To fully seat the spool, rotate as necessary,

taking care not to trap the line underneath

the spool, and making sure that there is a

minimum of 9cm (3.5") of line protruding

from the spool housing.

• Finally, replace the cover as previously

described.

What to do if your string trimmer

needs repair

For after sales service please refer to the section

‘Lawnmowers & Garden’ within your local

Yellow Pages.

Unwanted products and the

environment

Should you find one day that your trimmer

needs replacement, or is of no further

use to you, think of the protection of the

environment. Black & Decker service agents

will accept your old trimmer and will dispose

of it in an environmentally safe way.

Black & Decker lawn and garden

guarantee

lf your Black & Decker trimmer becomes defective,

within the guarantee period, due to faulty materials

and workmanship, we guarantee to either replace all

defective parts, or at our discretion, replace your

trimmer free of charge, provided that:

• Your trimmer is returned to one of our authorised

repair agents with evidence of purchase.

• Your trimmer has been used within the

parameters of its consumer classification.

• Your trimmer has not been used for hire purposes.

• Repairs have not been attempted by anyone

other than our authorised repair agents.

• The failure represents normal wear and tear.

This guarantee is offered as an extra benefit and is

additional to your statutory rights.

Our guarantee policy

Failure due to the following are not covered:

• Replacing worn or damaged blades, nylon line

and chains, or cables damaged during storage

or use. These are regarded as replacement items

which wear during normal usage.

• Failure as a result of sudden impact or obvious

abuse.

• Failure due to usage not in accordance with

instructions and recommendations contained in

this manual.

GL340 UK p02-11 w/p 24/3/00, 2:17 pm8

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker GL340 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info