Bedienungsanleitung Black Decker GL340 (Seite 11 von 16) (Englisch)

527583

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

ENGLISH

Do not cut wet grass, best results are

achieved when the grass is dry.

Cut at an angle and with the tip of the nylon

line. Your trimmer is balanced to operate at

this angle.

Swing your trimmer gently from side to side.

Do not overload your trimmer. It operates

best at high speeds.

On long grass, start at the top.

Take small cuts.

If your trimmer features a cord restraint,

loop a length of cord through the restraint to

prevent the plug and socket coming apart

accidentally if the cord is pulled.

How to fit a new spool of cutting line

(Fig. F & G)

• Disconnect your trimmer from the

power supply.

• Remove the spool cover by pushing the

two spool cover tabs (12) inwards and

upwards (Fig. F), then pull off (it is not

necessary to push both tabs in at the

same time). The empty spool can now

be withdrawn from the drive shaft.

• Remove any dirt or grass that may have

collected inside the spool housing and

cover.

• Unwind approximately 9cm (3.5") of

cutting line (5) from the new spool (15)

and temporarily park the cutting line end

in one of the ‘L’ shaped slots to prevent

the line unravelling.

• Feed the cutting line through the eyelet

(14) and then push the spool onto the

centre drive shaft while pulling the free

end of the line to release it from the ‘L’

shaped slot. To fully seat the spool,

rotate as necessary, taking care not to

trap the cutting line underneath the spool

and making sure that there is a minimum

of 9cm (3.5") protruding from the

spool housing.

• Replace the spool cover by aligning

both tabs on it (12) with the slots in the

spool housing and pushing them into

place. Make sure that both tabs are

securely located.

How to wind new line onto an empty

spool (Fig. H & J)

• A maximum of 10 metres of new cutting

line can be wound onto the empty spool.

The spool has an ‘Indicator’ to help you

avoid winding an excessive quantity of

cutting line on the spool, as too much will

prevent the automatic feed system from

functioning.

• Remove any remnant of old cutting line

from the spool (15).

• Push the end of the new cutting line into

one of the two retaining holes (17) provided

in the spool (15) and insert 20mm.

• Bend the cutting line over, pulling it

through the adjacent ‘L’ shaped slot.

The cutting line should now be firmly

anchored to the spool and you may

proceed to wind it on in the direction of

the arrow (16).

• Take time to wind the cutting line on

neatly, in layers. Do not criss cross.

• When you have wound on sufficient

cutting line, temporarily park it in one of

the ‘L’ shaped slots to prevent the spool

unravelling, ensuring you leave a

minimum of 9cm (3.5") protruding.

• Fit the spool and spool cover (8) to the

spool housing as described for fitting a

new spool.

Replacement line

A new spool containing 10 metres of nylon line may

be purchased from your Black & Decker agent.

Alternatively, replacement packs containing 25 to

50 metres of line are available.

For maximum reliability never put on a heavier or

lighter line (eg. fishing line) which will prevent the

automatic feed from functioning, cause motor failure

or reduce cutting performance.

Care and maintenance

• For the best performance, please keep the nylon

line, spool and air slots in your trimmer body

clean. Use a dry brush or cloth to remove grass,

sap or other dirt.

• Plastic parts may be cleaned by using a mild

soap and a cloth dampened with hot water.

Do not use any other type of detergent, cleaner

GL340 UK p02-11 w/p 24/3/00, 2:17 pm7

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker GL340 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info