Bedienungsanleitung Black Decker GL340 (Seite 10 von 16) (Englisch)

527583

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

• Remove cable clamp (see opposite, figure a).

Take care of loose parts.

• To connect the extension cable to the connector

terminals, unscrew the terminal screws until the

clamp washers have lifted just enough to enter

the conductor between the raised washer and

the terminal (see below). Connect the brown lead

to ‘L’ and the blue lead to ‘N’.

Note: There is no need to remove the terminal

screws. Connections are not to be made under

the screw heads.

terminal screw

clamp terminal

washer conductor

position

to left of screw

• Locate the cable and cable protector into the

body correctly (see below, figure a). Then fit the

cable clamp over the outer sheath of the cable

and screw down until the screws are fully home.

Failure to do this may result in the cover not

fitting correctly to the connector body.

• Before replacing the cover of the ‘female’

connector make sure that the cable clamp is

holding the outer sheath of the cable firmly with

screws fully home and that the two leads are

correctly fixed at the terminal screws and are not

taut (see below, figure a).

• Place the cover onto the body assembly

ensuring that it seats flat, then retighten the fixing

screw into the nut until the cover is securely held

(see below, figure c).

• Finally check that the cable protector is secure

and that there are no gaps between the cover

and the connector body.

terminal screws

clamping washers

connector body fixing screw

6mm

cable

clamp cover

cable

protector

Preparing your trimmer for use

(Fig. C - E)

• Take your trimmer, guard and parts pack

out of the carton.

• Remove the guard screws from the

parts pack.

• Place the guard (6) over the spool

housing (13) on your trimmer taking care

that the line (5) does not become stuck

between the two parts.

• Align the arrow (10) on the guard (6) with

the square marking (9) on your trimmer

body and push the guard upwards until it

contacts the underside of the body. Now

slide the guard forward until the square

marking on the guard aligns with the

square marking on your trimmer body.

Ensure that the ridge on the guard has

located in the slot on your trimmer body.

• Once the guard is in position, secure with

the two guard screws which go through

the guard screw holes (11) and into your

trimmer body.

• In transit, the end of the cutting line (5) is

taped to the side of the spool cover.

Please discard the tape to release the

length of line. There should be a

minimum length of 9cm (3.5") of cutting

line protruding from the spool housing

before you use your trimmer.

Note: When your trimmer is operated for the

first time, any excess line will be cut off by

the line trimming blade (7) housed in the

guard. This is also the case for any

subsequent line adjustment. Because line

cut off by the blade in the guard may be

ejected, it is important that the amount of

excess line is kept to a minimum. Where an

excessive amount of line is pulled out, the

line should be cut back to the outside of the

guard before switching on your trimmer. Cut

the line off on your trimmer blade by hand.

• Always ensure that the spool cover is

secure before and after use.

How to use your trimmer (Fig. B)

To switch on your trimmer press the switch

lever. To switch the unit off, release the

switch lever.

In order to get the most from your trimmer,

please learn the following techniques.

Do not be impatient, you will obtain the best

results by experience and by following these

simple rules.

Do not use your trimmer without its guard.

GL340 UK p02-11 w/p 24/3/00, 2:17 pm6

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker GL340 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info