Bedienungsanleitung Black Decker GL560PXC T5 (Seite 4 von 60) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

583265

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

Warning! Never connect Live or Neutral

wires to Earth pin marked ‘E’ or .

Fuse replacement (UK only)

Your machine is supplied with cable fitted

with a non-wireable plug.

• The plug is fitted with a 5 amp fuse

which is the recommended fuse for

your machine.

• Only use replacement fuses which are

approved to BS1362.

• When changing the fuse in your plug,

always ensure the fuse cover is refitted.

If the fuse cover is missing or damaged

do not use the plug.

Note: Fuses do not give personal protection

against electric shock. The recommended

Black & Decker RCD is available from your

nearest Black & Decker service centre.

Increased safety can be obtained by having

a qualified electrician install a high sensitivity

(30mA) circuit breaker in the house wiring.

If you do not have such a circuit breaker

installed, or you do not wish to have one

installed, then we strongly recommend that

the electrical power to the machine be

supplied through a high sensitivity residual

current device (RCD). The RCD is designed

to provide a high degree of personal

protection against harmful electric current

should fault conditions occur.

Warning! The use of an RCD or other circuit

breaker unit does not release the operator of

the machine from the safety instructions and

safe working practices given in this manual.

Extension cables and cordsets

You can use up to 100 feet (30 metres) extension

cord without undue loss of power. Extension cables

and cordsets should comply with national regulations.

Preparing the trimmer for use (Fig. 2)

• Take the trimmer and the guard (6) out of

the box.

• Remove the guard screw (22) which is

located on the base of the trimmer body

(1) (Fig. 2.1).

• Place the guard into the channel on the

trimmer body.

• Push the guard fully home until the guard

is flush with the body (Fig. 2.2).

• Replace the guard screw (Fig. 2.3).

• If correctly assembled, the guard will now

be secured to your trimmer.

• In transit, your trimmer is packed in

‘Edging’ mode, if you want to ‘Trim’ refer

to the section ‘How to convert between

the trimming and edging mode’.

• In transit, the end of the cutting line (5) is

taped to the side of the spool cover (8).

Please discard the tape to release the

length of line. There should be a

minimum of 9cm (3.5") of cutting line

protruding from the spool housing (12)

before using your trimmer.

Note: When your machine is operated for

the first time any excess line will be cut off by

the line trimming blade (7) housed in the

guard. This is also the case for any

subsequent line adjustment. Because line

cut off by the blade in the guard may be

ejected, it is important that the amount of

excess line is kept to a minimum. Where an

excessive amount of line is pulled out, the

line should be cut back to the outside of the

guard before switching on your trimmer. Cut

the line off on the trimmer blade by hand.

• Always ensure that the spool cover is

secure before and after use.

How to use your trimmer (Fig. A - K)

In order to get the most from your trimmer please be

sure to follow the techniques shown. Do not be

impatient; you will obtain the best results by

experience and by following these simple rules.

Do not use your trimmer without

its guard.

Do not cut wet grass; best results are

achieved when the grass is dry.

Trimming

• To switch on your trimmer, squeeze the

trigger switch (21).

• To switch the unit off, release the

trigger switch.

• To carry the trimmer when not in use,

it is preferred that you use the secondary

handle (2).

Cut at an angle and with the tip of the

cutting line (5).

Swing the trimmer gently from side to side.

Do not overload the trimmer. It operates best

at high speeds.

On long grass, start at the top.

Take small cuts.

Use the edge of the guard (6) to keep the

trimmer away from hard surfaces and

delicate items.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker GL560PXC T5 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Black Decker GL560PXC T5

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info