Bedienungsanleitung Bosch Aquatak 160 Pro X (Seite 15 von 98) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

79210

Zoom out

Zoom in

Vorherige Seite

1/98

Nächste Seite

English - 3

15 • F016 L70 375 • TMS • 21.10.05

Electrical Safety

Your machine requires an earth connection. The op-

erating voltage is 230 V AC, 50 Hz. (for non-EU

countries 220 V, 240 V as applicable). Only use ap-

proved extension cables. Contact your Bosch Serv-

ice Centre for details.

If you want to use an extension cable when operat-

ing your high pressure washer, only the following ca-

ble dimensions should be used:

1.5 mm

– max length 20 m

2.5 mm

– max length 50 m

Note: If an extension cable is used it must be

earthed and connected through the plug to the earth

cable of your supply network in accordance with pre-

scribed safety regulations.

If in doubt contact a qualified electrician or the near-

est Bosch Service Centre.

WARNING! Inadequate extension cables can be

dangerous. Extension cable, plug and socket

must be of watertight construction and intended

for outdoor use.

Cable connections should be kept dry and off

ground.

It is recommended for increased electrical safety to

use a Residual Current Device (RCD) with a tripping

current of not more than 30 mA. Always check your

RCD every time you use it.

For products not sold in GB: WARNING: For

safety, it is essential that the mains plug attached to

the product is fitted to the power supply cable . The

couplings of connection leads must be protected

against splashes and the coupling sockets on the

leads must be made of rubber or coated with rubber.

Fixing means for the connection leads must be

used.

If the supply cord is damaged, it must be replaced by

a Bosch Service Centre.

Products sold in GB only: Your product is fitted with

an approved 13 A (BS 1363/A) electric plug and is

protected by a 13 A fuse (ASTA Approved to

BS 1362).

If the fitted plug is not suitable for your socket out-

lets, it should be cut off and an appropriate plug fit-

ted in its place.

The severed plug must be disposed of to avoid a

possible shock hazard and should never be inserted

into a 13 A socket elsewhere.

Before use

Assemble storage hook(s) 8 to handle. Push

firmly to ensure hook is secure.

Fit handle 5 to hose reel using supplied screw.

(Aquatak 150 PRO X/160 PRO X only)

Water connection

Screw inlet connector 16 onto machine water in-

let connection 13.

Attach water supply hose (not supplied) to the mains

water supply and machine.

Connecting high pressure water supply hose/

nozzle

/ Securely screw high pressure hose 3 onto

machine at connection 17 and to the power gun 7.

(AQUATAK 150 PRO)

Securely screw the high pressure hose 3 to the

power gun 7. (AQUATAK 150 PRO X/160 PRO X)

Inserting the vario-jet/fan power lance 9 into the

power gun 7. Depress and turn the vario-jet/fan

power lance 90° clockwise to lock in place. (AQUA-

TAK 150 PRO/150 PRO X)

Screw the vario jet-fan power lance 9 into the power

gun 7. (AQUATAK 160 PRO X)

Aquatak 150 PRO X/160 PRO X only

Unwind the pressure hose 3 off the hose drum 4.

Never use the pressure washer with the high pres-

sure hose 3 on the hose drum 4.

Vario-jet-fan power lance

AQUATAK 150 PRO/150 PRO X

Twist the front ring to adjust from a pencil to a fan

jet and vice versa.

To apply the detergent twist the rear ring as

shown from high pressure mode to low pressure

mode.

To adjust the spray pattern twist the front ring.

Also refer to Advice on using pressure washer re-

garding the detergent suction rate.

For Your Safety

Warning! Switch off, remove plug from mains

before adjusting, cleaning or if cable is cut,

damaged or entangled.

Assembly

Adjustments and using different

nozzles

F016 L70 375 - GB Seite 3 Montag, 14. November 2005 1:15 13

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch Aquatak 160 Pro X Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bosch Aquatak 160 Pro X

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info