613636
76
Zoom out
Zoom in
Vorherige Seite
1/88
Nächste Seite
74
APPENDIX — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Troubleshooting
If the machine stops operating correctly, check the following possible problems before requesting service.
If the problem persists, contact your retailer or the nearest authorized service center.
Symptom Probable Cause Remedy Reference
The machine does
not operate.
The machine is not turned on. Turn on the machine. page 19
The start/stop button was not
pressed.
Press the start/stop button. page 58
The presser foot lever is raised. Lower the presser foot lever. page 58
The embroidery unit is not
attached on the machine.
Attach the embroidery unit. page 15
The needle breaks.
The needle is incorrectly installed. Correctly install the needle.
page 36The needle clamp screw is loose.
Use the screwdriver to firmly tighten
the screw.
The needle is bent or blunt. Replace the needle.
The upper thread tension is too
tight.
Loosen the upper thread tension. page 64
The spool is incorrectly installed. Correctly install the spool. page 30
The area around the hole in the
needle plate is scratched, or has a
burr on it.
Replace the needle plate. Contact
your retailer or the nearest authorized
service center.
The area around the hole in the
embroidery foot is scratched, or
has a burr on it.
Replace the embroidery foot. Contact
your retailer or the nearest authorized
service center.
The bobbin case is scratched, or
has a burr on it.
Replace the bobbin case. Contact
your retailer or the nearest authorized
service center.
A bobbin designed specifically for
this machine is not used.
Incorrect bobbins will not work
properly. Only use a bobbin
designed specifically for this
machine.
page 24
The upper thread
breaks.
The upper thread was not
threaded correctly (for example,
the spool is not installed correctly,
the spool cap is too big for the
spool being used, or the thread
has come out of the needle bar
thread guide).
Correct the upper threading. page 30
There are knots or tangles in the
thread.
Remove any knots or tangles.
The upper thread tension is too
tight.
Loosen the upper thread tension. page 64
76

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Brother Innov-is 700E II wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Brother Innov-is 700E II

Brother Innov-is 700E II Kurzanleitung - Deutsch - 24 seiten

Brother Innov-is 700E II Bedienungsanleitung - Deutsch - 88 seiten

Brother Innov-is 700E II Kurzanleitung - Englisch, Holländisch - 24 seiten

Brother Innov-is 700E II Bedienungsanleitung - Holländisch - 88 seiten

Brother Innov-is 700E II Kurzanleitung - Französisch - 24 seiten

Brother Innov-is 700E II Bedienungsanleitung - Französisch - 88 seiten

Brother Innov-is 700E II Kurzanleitung - Italienisch, Spanisch - 24 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info