Bedienungsanleitung Cambridge Audio AXA35 (Seite 4 von 10) (Englisch)

699770

Zoom out

Zoom in

Vorherige Seite

1/10

Nächste Seite

SUPPLIER’S DECLARATION OF CONFORMITY

(SDOC)

Equipment: Integrated Amplier

Model: AXA35

Trademark: Cambridge Audio

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that

may cause undesired operation.

The responsible party in US:

Company name: Audio Partnership LLC

Address: 1913 N Milwaukee Ave. Chicago, IL 60647

Phone: (312) 636-4817

Legal Representative Person: Gregg Chopper

Signature:

VENTILATION

Important! The unit will become hot when in use. Do not stack multiple units on top

of each other.

Ensure that small objects do not fall through any ventilation grille. If this happens,

switch o immediately, disconnect from the mains supply and contact your dealer

for advice.

POSITIONING

Choose the installation location carefully. Avoid placing it in direct sunlight or close

to a source of heat. No naked ame sources, such as lighted candles, should be placed

on the unit. Also avoid locations subject to vibration and excessive dust, cold or

moisture. The unit can be used in a moderate climate.

This unit must be installed on a sturdy, level surface. Do not place in a sealed area

such as a bookcase or in a cabinet. Do not place the unit on an unstable surface or

shelf. The unit may fall, causing serious injury to a child or adult as well as serious

damage to the product. Do not place other equipment on top of the unit.

Due to stray magnetic elds, turntables or CRT TVs should not be located nearby due

to possible interference.

Electronic audio components have a running in period of around a week (if used

several hours per day). This will allow the new components to settle down and the

sonic properties will improve over this time.

Plug Fitting Instructions (UK Only)

The cord supplied with this appliance is factory tted with a UK mains plug tted

with a 3 amp fuse inside. If it is necessary to change the fuse, it is important that a 3

amp one is used. If the plug needs to be changed because it is not suitable for your

socket, or becomes damaged, it should be cut o and an appropriate plug tted

following the wiring instructions below. The plug must then be disposed of safely,

as insertion into a mains socket is likely to cause an electrical hazard. Should it be

necessary to t a 3-pin BS mains plug to the power cord the wires should be tted as

shown in this diagram. The colours of the wires in the mains lead of this appliance

may not correspond with the coloured markings identifying the terminals in your

plug. Connect them as follows:

The wire which is coloured BLUE must be

connected to the terminal which is marked with

the letter ‘N’ or coloured BLACK.

The wire which is coloured BROWN must be

connected to the terminal which is marked with

the letter ‘L’ or coloured RED.

The wire which is coloured GREEN/YELLOW

must be connected to the terminal which is

marked with the letter ‘E’ or coloured GREEN.

If a 13 amp (BS 1363) plug is used, a 5 amp fuse

must be tted, or if any other type of plug is used

a 5 amp fuse must be tted, either in the plug or

adaptor, or on the distribution board.

POWER SOURCES

The unit should be operated only from the type of power source indicated on the

marking label. If you are not sure of the type of power-supply to your home, consult

your product dealer or local power company.

If you do not intend to use this unit for a long period of time, unplug it from the

mains socket.

OVERLOADING

Do not overload wall outlets or extension cords as this can result in a risk of re or

electric shock. Overloaded AC outlets, extension cords, frayed power cords, damaged

or cracked wire insulation and broken plugs are dangerous. They may result in a

shock or re hazard.

Be sure to insert each power cord securely. To prevent hum and noise, do not bundle

the interconnect leads with the power cord or speaker leads.

CLEANING

To clean the unit, wipe its case with a dry, lint-free cloth. Do not use any cleaning

uids containing alcohol, ammonia or abrasives. Do not spray an aerosol at or near

the unit.

BATTERY DISPOSAL

Batteries may contain substances harmful to the environment. Please dispose

of any discharged batteries with due consideration and in accordance with local

environmental/electronic recycling guidelines.

SERVICING

These units are not user serviceable. Never attempt to repair, disassemble or

reconstruct the unit if there seems to be a problem. A serious electric shock could

result if this precautionary measure is ignored. In the event of a problem or failure,

please contact your dealer.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cambridge Audio AXA35 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cambridge Audio AXA35

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info