Bedienungsanleitung Charlton Jenrick Fireline Woodtec 5 (Seite 8 von 28) (Englisch)

707656

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

7 Woodtec Freestanding Issue 01.1 05/17

4.1.5. Fuels

Only use recommended fuels which are seasoned (or kiln dried) wood logs. The appliance can

be damaged by burning petroleum coke, liquid fuels or general rubbish and this will invalidate

your warranty and risk your personal safety. The appliance must not be used as a rubbish

incinerator.

4.1.6. Maintenance

Annual checking and servicing of the appliance and flue by a competent engineer is

recommended.

4.1.7. Ventilation

Adequate ventilation is ESSENTIAL for the safe and efficient operation of any solid fuel or wood

burning appliance. Ventilation MUST be provided where required by the stove output or flue

under-performance. Keep all ventilation clear and free of blockage, including the direct outside

air connection where used. See VENTILATION in INSTALLATION INFORMATION section.

4.2. Health And Safety Precautions

Special care must be taken when installing this stove to meet all requirements of the Health &

Safety at Work act.

4.2.1. Handling

Adequate facilities must be available for unloading and site handling. Stoves are very heavily

built so always ask for assistance when lifting and siting them. See Technical Data for weights.

4.2.2. Fire Cement

Some types of fire cement are caustic and should not be allowed to come into contact with the

skin. In case of skin contact, wash immediately with plenty of water.

4.2.3. Asbestos

This stove contains no asbestos. If there is a possibility of disturbing any asbestos in the course

of installation then please seek specialist guidance and use appropriate protective equipment.

4.2.4. Metal Parts

When installing or servicing this stove, proper care should be taken to avoid the possibility of

personal injury. Injury may be caused by component weight, sharp parts or trapping for example

and these risks should be identified and minimised.

5.0 Installation Information

5.1. Chimney/flue

The chimney height and the position of the chimney terminal should conform to Building

Regulations. Minimum chimney height is 4.5m and the recommended minimum diameter is

150mm wherever possible for safety margin and performance. The chimney must be swept

before connection to the stove. Check that the chimney is in good condition, dry and free from

cracks and obstructions. The diameter of the flue should not be less than 125mm (spigot

diameter) at any point and not greater than 200mm. If any of these requirements are not met,

the chimney should be lined by a suitable method. When using a liner a 6” diameter is strongly

recommended where it can be used but failing that a 5” flexible flue liner is permitted be used

for these stoves providing that the users only burns smokeless fuel or seasoned wood logs with

the air limiter fitted in in full accordance with the wood burning instructions.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Charlton Jenrick Fireline Woodtec 5 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info