Bedienungsanleitung Charnwood SLX 45 MKII - Multi fuel (Seite 7 von 20) (Englisch)

815485

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

maximum and wait until flames appear above the fuel bed before

opening the doors.

Burning coal will produce more soot deposits than other fuels,

especially if the fire is run at low levels for long periods. It is

therefore vital to clean the throat plate regularly, daily cleaning is

recommended.

MAINTENANCE

Cleaning

To clean

the surfaces simply wipe over with a dry cloth. Abrasive pads and

scouring cleaners must not be used as these will damage the finish.

Care should be taken not to knock the enamel with hard objects as it

will chip.

Cleaning the Glass

The glass in the doors is a special ceramic glass which is able to

withstand high temperatures. Before cleaning the glass open the

doors and allow them to cool. Clean the glass using a damp cloth

and then wiping over with a dry cloth. Any stubborn deposits on the

glass may be removed with a proprietary stove glass cleaner or

ceramic hob cleaner. Some deposits on the glass may be burnt off

simply by running the fire at a fast rate for a few minutes. Do not

use abrasive cleaners or pads as these can scratch the surface which

will weaken the glass and cause premature failure. Aerosol spray

cleaners should not be used near the appliance whilst it is under fire.

When not in use

If the fire is going to be out of use for a long period, (for instance in

the summer,) then to prevent condensation, and hence corrosion,

the thermostat should be left at the maximum setting and the main

doors left ajar. It is also advisable to sweep the chimney and clean

out the fire. Spraying the inside of the doors and firebox with a light

oil, such as WD40, will also help to keep all internal parts working

well.

After long periods where the fire has been out of use, the chimney

and appliance flueways should be cleaned before lighting.

Door Seals

For the fire to operate correctly it is important that the door seals

are in good condition. Check that they do not become worn or

frayed and replace them when necessary.

Please also note that when burning coal, some

blackening of the glass may occur.

The appliance is finished in silicone paint or vitreous enamel.

Servicing

It is recommended that the fire is serviced once a year to keep it in

first class working order. After cleaning out the firebox thoroughly,

check that all internal parts are in good working order

CHIMNEY SWEEPING

The chimney should be swept at least twice a year. In most

installations it will be possible to sweep the chimney through the

appliance.

First remove the front firebars and the throat plate. Then sweep the

chimney ensuring that soot is removed from all horizontal surfaces

after sweeping.

In situations where it is not possible to sweep through the appliance

the installer will have provided alternative means, such as a soot

door. After sweeping the chimney the appliance flue outlet and the

flue pipe connecting the appliance to the chimney must be cleaned

with a flue brush.

After clearing any soot from within the fire, replace the throat plate

and the front firebars.

Different types of sweep’s brushes are available to suit different

flueways. For standard brick chimneys a wire centre sweep’s brush

fitted with a guide wheel is recommended. For prefabricated

insulated chimneys the manufacturers instructions with regard to

sweeping should be consulted.

, replacing any

parts that are beginning to show signs of wear. Check that the door

seals are in good condition and that the door seals correctly. A

servicing guide is available on request. Repairs or modifications may

only be carried out by the Manufacturer or their approved agents.

Use only genuine Charnwood replacement parts.

Where the chimney previously served an open fire, it is possible

that the higher flue gas temperature from a stove may loosen soot

deposits with the consequent risk of flue blockage. It is therefore

recommended that the chimney be swept a second time within a

month of regular use after installation.

charnwood

OPERATING INSTRUCTIONS SLX45

MU LT I-F UEL

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Charnwood SLX 45 MKII - Multi fuel Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info