Bedienungsanleitung Charnwood SLX 45 MKII - Multi fuel (Seite 8 von 20) (Englisch)

815485

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

TROUBLE SHOOTING

Fire Will Not Burn

Check that:

a) the air inlet is not obstructed in any way,

b) chimneys and flueways are clear,

c) a suitable fuel is being used,

d) there is an adequate air supply into the room,

e) an extractor fan is not fitted in the same room as the fire,

Fire Blazing Out Of Control

Check that:

a) the doors are tightly closed,

b) the thermostat knob is turned down to the minimum setting,

c) the air inlet damper is closed (at the bottom left of the appliance,

see Fig. 1.), and that it is not prevented from closing completely by a

piece of ash,

d) a suitable fuel is being used,

e) the door seals are in good condition.

Over-Firing

If the fire is over-fired it will cause premature failure of the internal

fire parts. Over-firing is occurring when any internal parts of the fire

begin to glow red. To prevent over-firing ensure that:

a) the door seals are kept in good condition, and that the doors are

sealing correctly,

b) the thermostat on the fire is working correctly,

c) a suitable fuel is being used,

d) the fire is not fitted onto a heating system which is too large.

f) there is sufficient draw in the chimney. Once the chimney is warm

a draught reading of at least 2.5 mm (0.10 inches) water gauge

(25Pa) should be obtained.

Fume Emission

Warning Note: Properly installed, operated and maintained this

appliance will not emit fumes into the room. Occasional fumes

from de-ashing and re-fueling may occur. Persistent fume

emission is potentially dangerous and must not be tolerated. If

fume emission does persist then take the following immediate

actions should be taken:

a) Open doors and windows to ventilate the room and then leave

the premises.

b) Let the fire out and safely dispose of the fuel from the

appliance.

c) Check for flue or chimney blockage, and clean if required.

d) Do not attempt to relight fire until cause of fume has been

identified and corrected, if necessary seek professional advise.

The most common cause of fume emission is flueway or chimney

blockage. For you own safety these must be kept clean.

Blackening of Door Glass

Differences in chimney draughts mean that the best setting of the air

controls will vary for different installations. A certain amount of

experimentation may be required, however the following points

should be noted and with a little care should enable the glass to be

kept clean in most situations:

a) The airwash relies on a supply of heated air to keep the glass

clean, therefore, when lighting the stove allow the firebed to become

well established before turning the thermostat down. It may

Freezing

Do not light the fire if there is any possibility that any parts of the

system may be frozen.

Chimney Fires

If the chimney is thoroughly and regularly swept, chimney fires

should not occur. However, if a chimney fire does occur then turn

the control knob to the minimum setting (see Fig. 1), and tightly

close the doors of the appliance. This should cause the chimney fire

to go out in which case the control should be kept at the minimum

setting until the fire in the appliance has gone out. The chimney and

flueways should then be cleaned. If the chimney fire does not go out

when the above action is taken then the fire brigade should be

called immediately.

After a chimney fire the chimney should be carefully examined for

any damage. Expert advice should be sought if necessary.

Lack of Heat To Radiators / Hot Water

Check that:

a) the fire is burning properly - if not then carry out the checks

under "Fire Will Not Burn".

b) the throat plate is fitted correctly, i.e. pushed back against the

boiler, and that it is not distorted.

c) the door seals are in good condition.

d) If the hot water goes cold when the pump is turned on, or if some

radiators are hotter than others, then the system may need

balancing, the pump may be pumping the water too quickly around

the system, or the radiators may need bleeding. Please ask your

installer to check these points.

charnwood

OPERATING INSTRUCTIONS SLX45

MU LT I-F UEL

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Charnwood SLX 45 MKII - Multi fuel Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info