Bedienungsanleitung Derby Cycle Pedelec Xion 2013 (Seite 57 von 259) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

658408

Zoom out

Zoom in

Vorherige Seite

1/259

Nächste Seite

24 VIII User Manual Pedelec Xion

› In the as-delivered condition, the battery is not

lly charged and is in what is referred to as

sleep mode. Sleep mode minimises the rate at

which the battery discharges itself. If the bat-

tery is allowed to discharge unchecked for an

extended period this can lead to total discharg-

ing which damages the battery. To “wake up” the

battery, simply charge it up again.

› If you are having problems with the battery,

charge it for one minute initially. A reset occurs,

during which the battery management disables

sleep mode, for example. Aer this, the battery

will work again.

› Ideally you should charge the battery at a tem-

perature of between +10°C and +30°C. It takes

longer to charge the battery at low temperatures,

while the battery will not charge up at tempera-

tures higher than +45°C. Ideally, you should

charge and store the battery inside your house or

in a warm garage when the outside temperature

is low. In this case you should only t the battery

on your bike just before using it.

› If you are transporting your Pedelec by car, take

the battery out of its holder and transport it

separately.

› The battery should ideally be stored for longer

periods with a charge state of 50% to 75% at a

temperature of +10°C.

7.3 Straightforward storage

• If you do not need your battery for a while, store it

at a temperature of +10°C at three quarters of its

ll charge capacity.

• The battery management switches the battery to

sleep mode to prevent a so-called total discharge.

This can occur aer dierent lengths of time with-

out being used. Depending on the charge state

of the battery, this can occur earlier with a lower

charge and later with a higher charge. The mana-

gement system activates the sleep mode aer

48hours without using the battery. The system

exits sleep mode when you press the button with

LED on the battery.

These benets are available due to highly eective

battery management that has been adapted to this

specic application and by tuning the battery for

operation with a 250 watt motor.

Observe the following points to increase the service

life of your Pedelec battery:

› Make sure that the battery is lly charged before

you ride your bike for the rst time or if you have

not used it for a while.

› If you continuously run the battery to empty

during normal operation, this reduces its ser-

vice life. If you partially recharge the battery

equently during normal operation, this has a

favourable eect on its service life.

› You should therefore partially recharge the

battery whenever possible: Try not to run the

battery all the way down to empty and recharge

it even aer a short period of operation.

Charging times at dierent temperatures

Battery may be

damaged

Optimum temperature

range for charging

operation

Long charging times

-10°C 0°C 10°C 20°C 30°C 40°C 50°C

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Derby Cycle Pedelec Xion 2013 Seite 57

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info