Bedienungsanleitung Derby Cycle Pedelec Xion 2013 (Seite 58 von 259) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

658408

Zoom out

Zoom in

Vorherige Seite

1/259

Nächste Seite

VIII User Manual Pedelec Xion 25

* All ve LEDs ash quickly: The battery is empty and is

being switched o, is overloaded or is going through the

start mode.

• If the battery is empty, it will work once again

briey following a short period of rejuvenation and

will then switch back o. It must now be recharged

• If the battery is overloaded, it will switch back

on aer a short idle period and can then be used

normally.

** The rst LED ashes quickly: A charging fault is pre-

sent.

• In that case, please remove the mains plug om

the socket and then plug it in again aer a short

time. The charger performs a readjustment. In most

cases, this recties the fault.

• If the LED continues to ash, overheating or under-

cooling of the battery may also be the cause. If, for

example, you charge the battery in a cold environ-

ment at a temperature below 0°C, or the battery

heats up to over 60°C during a long ascent, the

management switches o to protect the battery. In

such cases, the battery must be taken to a warmer

environment or cool down.

• If the LED still ashes, take the battery to your

specialist cycle shop and have it checked.

7.4.2 Checking the battery capacity

When you press the button with the LED for approx. three

seconds, the LEDs indicate the charge state rst, and then,

aer a short pause, the current capacity of the battery. If

the LED in the largest panel lights up, then the battery has

a capacity of over 60%. If the capacity is below 60%, this

is indicated via the smallest LED. Only one of the two LEDs

can light up at any one time.

The range of the battery is less in winter due to the

lower temperatures. Only move the battery (om the

warm room where you store it) and t it on your Pe-

delec just before you set o. This will help to prevent

the eect of the low temperature on the range of the

battery (➠ Chapter 7.5.1 “Service life and warranty

of the battery”).

7.4 Battery information system

There is a display panel on the outer face of the battery

which includes ve LEDs and a button with an LED. The

LEDs light up if you press the button. Information about

the battery and its charge state is provided based on the

number of LEDs that light up and the way in which they

light up.

Battery charge state

7.4.1 Checking the battery charge state

Press the button with the LED briey; the LEDs light up

and display the current battery charge state.

AFFICHAGE

ÉTAT DE CHARGE DE LA

BATTERIE

•••••

5 LEDs light up 100 – %

••••

4 LEDs light up  – %

•••

3 LEDs light up  – %

••

2 LEDs light up  – %

•

1 LED lights up  – %

1 LED ashes  – %

5 LEDs ash

quickly

%, surcharge ou la

batterie est en mode de

démarrage*

LED ashes

quickly

Erreur de chargement **

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Derby Cycle Pedelec Xion 2013 Seite 58

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info