Bedienungsanleitung Dimplex Toluca DeLuxe (Seite 4 von 8) (Englisch)

706502

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

Operating Instructions:

Please see Fig. 3

Icon Display Funtion Description

A -

Power /

Standby

Press Once to turn the product ‘ON’.

Press a second time to put the product into ‘STANDBY’

(When returning from ‘STANDBY’ mode the product will return to previous settings unless

the product has been unplugged, in which case it will reset to factory settings)

‘FLAME EFFECT’ button this turns the ame effect ON or OFF independently of the

products other features.

Flame

This Button will increase the brightness of the ame effect. There are 5 brightness settings

shown as F1, F2, F3, F4, F5. This button will ONLY increase the brightness level.

Flame

Down

This Button will decrease the brightness of the ame effect. There are 5 brightness settings

shown as F1, F2, F3, F4, F5. This button will ONLY decrease the brightness level.

Flame

Cycling

This setting is set by pressing the Flame Up button once more after F5. this will cause the

brightness of the ame effect to cycle from F2 to F5 in a continuous Loop.

Off

This will turn the ame effect off. If the heater is ON, the display will activate and remain

active to read the set temperature and show if the product is on LOW HEAT/ HIGH HEAT/

COOL BLOW.

‘HEAT’ button cycles the unit sequentially through the 4 settings: LOW HEAT, HIGH HEAT,

COOL BLOW and OFF. The heat setting will be indicated by an icon in the display see Fig.1.

When the ame effect is ‘ON’ the display will turn off after 5 seconds, however if the

heater is being used independently of the ame effect. The low heat or high heat icon

will appear continuously in the display.

Low

Heat

This setting will run the heater at ‘LOW HEAT’ this setting will be indicated by the ‘LOW HEAT’

icon. To Adjust the temperature setting the Temp Down or Temp Up buttons described

below must be used.

(This icon is Orange in Colour)

High

Heat

This icon in the display indicates ‘HIGH HEAT’ this setting will be indicated by the ‘HIGH

HEAT’ icon. To Adjust the temperature setting the Temp Down or Temp Up buttons

described below must be used.

(This icon is Red in Colour)

Cool

Blow

This icon in the display indicates ‘COOL BLOW’ this setting will be indicated by the ‘COOL

BLOW’ icon and the letters ‘CB’ appearing in the display.

(This icon is Blue in Colour)

- Off

This switches the heater and blower ‘OFF’, no icon will be displayed in the display. Note

the blower will run for 5-10 seconds after being turned off, this is to ensure the product

cools down safely.

D -

Back

Light

Pressing this button will turn ON and OFF the Back Lighting. There are 4 settings, Sides

only, Top only, all OFF and All ON

E -

Temp

Down

Press multiple times to lower the heater temperature in 1

C increments. The lowest

temperature that can be set is 18

E -

Temp

Press multiple times to increase the heater temperature in 1

C increments. The highest

temperature that can be set 30

When High Heat is selected, the letters ‘HH’ appear in the display, this means the heat

will remain ON continusously and is not controlled by the thermostat.

Sleep

Timer

Press multiple times to change the ‘SLEEP TIMER’ in 0.5 hr increments from 0.5

h r t o 8 . 0 h r b e f o r e t u r n i n g o f f . T h e r e m a i n i n g t i m e o n t h e ‘ S L E E P T I M E R ’ d i s p l a y s .

(This icon is Green in Colour)

Volume

down

Pressing multiple times to control the volume level of the speaker down to mute.

When Bluetooth is not connected, the speaker will play sound of a fire, this can be

turned OFF by pressing this button until the sound is muted.

Volume

Controls the level of the speaker Volume up.

The volume buttons can also control the volume of your paired bluetooth device

H -

Blue-

tooth

When a device is paired to the product, pressing this button will disconnect the paired

device.

I -

LED

COLOUR

Press multiple times to change the colour of the LED mood lighting and the coloured

fuel bed. The colour can be set as Orange, Red, Green, Blue, or cycling through all four

colours continuously.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dimplex Toluca DeLuxe Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info