Bedienungsanleitung Dimplex Toluca DeLuxe (Seite 6 von 8) (Englisch)

706502

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

Maintenance

WARNING: ALWAYS DISCONNECT FROM THE POWER

SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE.

Cleaning

WARNING: ALWAYS DISCONNECT FROM THE POWER

SUPPLY BEFORE CLEANING THE HEATER.

For general cleaning use a soft clean duster – never use

abrasive cleaners. The glass viewing screen should be

cleaned carefully with a soft cloth.

DO NOT use proprietary glass cleaners.

To remove any accumulation of dust or uff the soft brush

attachment of a vacuum cleaner should occasionally be

used to clean the outlet grille of the fan heater.

WARNING: do not operate the product without the grille

and outer glass in position as this may effect the operation

of the heater.

Recycling

For electrical products sold within the

European Community. At the end of the

electrical products useful life it should not

be disposed of with household waste. Please

recycle where facilities exist. Check with

your Local Authority or retailer for recycling

advice in your country.

Servicing

Except for installation and cleaning described in this

manual, an authorized service representative should

perform any other servicing.

Fuel Bed Media

Acrylic Ice Crystals and White Pebbles are supplied in the

box with your re. allowing you the option of which to place

on your re. To Fit the Acrylic Ice Crystals, place the small

Crystals on the fuel bed tray, then place the larger crystals

on top of the small pieces. Arrange the larger pieces to your

liking. A suggestion is to place one large crystal centrally on

the fuel bed and the other four positioned symmetrically

around this piece.

The White pebbles are placed on the fuel bed tray until the

tray is completely covered by pebbles to your liking.

Fitting the Front Glass- See Fig. 5

Your new re is supplied with the front glass not secured to

the engine, this is to keep the glass safe in transit. To t the

glass to your re, simply insert the four hangers on the back

of the glass through the slots provided on the chassis. The

hangers go in through the slots and then move down to

hold the glass in place. The glass can then be secured in

place by inserting the small black screw provided through

the hole in any one of the hangers into the side of the unit.

Thermal Safety Cut-out

The built-in overheat cut-out switches the appliance off

automatically in the event of a fault. If this occurs switch off

the appliance or disconnect the mains plug from the socket.

After a short cooling down phase, the appliance is ready for

use again. If the fault should occur again, see your local dealer.

Light Emitting Diode

This re is tted with LED (Light Emitting Diode) bulbs in place

of traditional incandescent bulbs. These generate the same

light levels as traditional bulbs, but use a fraction of the energy

consumed.These bulbs cannot be replaced.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dimplex Toluca DeLuxe Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info