Bedienungsanleitung DRU Cosmo Tunnel (Seite 6 von 40) (Englisch)

810284

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

English

INSTALLATION MANUAL

5. Installation

5.1 Type of gas

The data plate indicates for which type of gas, gas pressure and for which country this appliance is intended.

The data plate can be found on the appliance or can be attached to a chain to which it should remain attached.

!Caution

Check whether the appliance is suitable for the type of gas and gas pressure used at the location.

5.1.1 Reconstruction to different type of gas

In order to convert this appliance to a different type of gas, please contact DRU's service department and ask for

the possibilities.

5.2 Gas connection

Place a gas tap in the gas pipe in accordance with the applicable regulations.

The gas connection on the gas control is located next to the receiver (see Appendix 3, fig. 38 (G)).

!Caution

• Make sure there is no dirt in the gas pipes and connections.

• No soldering may take place at the flexible gas hose(s), as this could cause leaks.

The following requirements apply to the gas connection:

• Use a gas pipe with the correct dimensions, so that no pressure loss can occur.

• The gas tap must be approved (in the EU this will be the CE mark).

• You should always be able to reach the gas tap.

5.3 Electric connection

In case of a 230 Volt electrical connection, provide proper grounding. Place this electrical connection away from

the appliance, as low as possible in the chimney breast. This has to do with the temperature development in the

chimney breast.

!Caution

Make sure that it is easy to disconnect the appliance from the power supply after installation;

• by disconnecting the plug;

• or by means of a 2-core switch installed by a recognised installer in accordance with current regulations.

!Caution

• Protect the gas control and electric components, hereafter referred to as the gas control, against building

dust and moisture!

• For connecting the receiver and control panel at an appliance equipped with the CM system ®, you must

observe the instructions in the supplied manual.

5.3.1 Connecting the switch contact (if applicable)

It is possible to operate one or more lamps (in case of several lamps, a maximum of 0.5A/250VAC/30VDC) via the

remote control of the appliance. You could think of the lamps of Dru's lux elements. For this, you can use switch

contact B on the receiver (see appendix 3, fig 36). The switch contact is not polar sensitive.

5.3.2 Connection extra power supply (max. 80W, 230VAC) (if applicable)

This connection is ideal for possible lighting or a ventilation system in the chimney breast and can be operated by

means of the remote control (see appendix 3, fig. 36 (C)). The power supply of this connection is identical to the

mains voltage and it can be subjected to a maximum load of 80 Watts.

5.4 Placing the appliance

!Caution

• Place the appliance in front of a heat-resistant and non combustible wall. The wall brackets on a built-in

appliance ensure that the minimum distance to the wall is maintained.

• Ensure there are no combustible objects or materials present in the fire's radiation range, within a distance of

500 mm, unless indicated otherwise.

• Place the concentric system in such a way that no fire hazard is ever created (also see section 5.8).

• Take sufficient measures to prevent temperature of a wall behind the chimney breast becoming too high,

including the materials and/or objects behind the wall.

• Do not cover the appliance and/or do not wrap it in an insulation blanket or any other material.

• Make sure that the appliance to be installed has a stable position. Fasten possible extending legs with the

self-tapping screws.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DRU Cosmo Tunnel Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von DRU Cosmo Tunnel

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info