Bedienungsanleitung DRU Cosmo Tunnel (Seite 13 von 40) (Englisch)

810284

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

English

INSTALLATION MANUAL

5.12 Glass pane

!Caution

The glass pane must be removed/placed by two persons.

!Caution

• Avoid damaging the glass panes when removing/placing them;

• avoid/remove fingerprints on the glass panes, as they will burn into the glass.

5.12.1 Removing the glass pane

When removing the glass pane, please observe the following steps (see appendix 3, fig. 7 up to 9):

Loosen the bolt (T) in the lock bracket (U) by 3 turns (see appendix 3, fig. 7a (1)).

Turn the lock bracket (U) to the left by a quarter turn. This will unlock the handle (X), by means of which the glass

pane can be opened.

!Caution

Always prevent the glass pane from falling forwards!

Pull the lever (X) down, using your index fingers. Press down the glass pane while the lever (X) is moved to the

right 180° and hold on to the glass pane! This will prevent the glass pane from falling forwards and getting

damaged (see appendix 3, fig. 7a (2 and 3)).

Carefully pull the glass pane towards the front with the two handles located at the left and right top side of the

glass pane frame and then allow the glass pane to drop (see appendix 3, fig. 7b).

!Caution

• The following actions should be performed by 2 persons.

• Prevent stresses on the glass pane by performing the following actions simultaneously on the left and right

side.

Simultaneously loosen the left and right brackets (Y) that guide the glass pane and connect it to the appliance.

Push close the glass pane with 2 persons at both sides, to such an extent that the brackets (Y) can be lifted from

the guides (see appendix 3, fig. 8).

Then, carefully remove the glass pane with 2 persons from the lower glass pane guides at both sides of the

appliance (see appendix 3, fig. 9).

5.12.2 Placing the glass pane

The glass pane is fitted by using the above procedure in reverse order (see appendix 3, fig. 7 up to 9).

!Caution

Avoid/remove fingerprints on the glass pane, as they will burn into the glass.

Pay attention to the following when fitting the glass window:

!Caution

Make sure the cams at the bottom on both sides of the glass pane frame are correctly placed in the guides at the

bottom of the combustion chamber by 2 persons (see appendix 3, fig. 9)!

!Caution

Check whether the 2 “clips” (C) are still properly attached around the bottom of the glass pane before the glass

pane is closed, in order to prevent it from getting damaged.

!Caution

First press the glass pane in its place at the upper corners and then hold the glass pane with 1 hand before sliding

the handle to the left again. Otherwise, the projections will not fall over the glass pane, as a result which it will not

close properly.

Turn the lock bracket (U) back to its position and re-tighten the bolt (T).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DRU Cosmo Tunnel Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von DRU Cosmo Tunnel

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info