6.1.2 Changing the cutting blocks
Caution: danger of injury
The cutting-block may only be changed with the machine
switched off.
Removing the cutting-block
–
Disconnect the compressed-air supply
–
Use a screwdriver 2 to push gently the cutting-block holder 1
downward.
–
Loosen the screw 3.
–
Pull out the cutting-block 4 to the left.
Fitting the cutting-block
–
Insert the cutting-block 4 in the guide and tighten the screw 3.
–
Connect the compressed-air supply again.
Hint
The cutting-block 1 will then move automatically upward, after the
compressed-air hose is connected.
Hint
If a cutting block with a different length has to be inserted, the control
panel has to be set accordingly.
(See service instructions chapter 29.4.8)
21
21
43
