9 Switching on - Switching off - Threading mode
9.1 Switching on
–
Switch on the main switch 1.
The machine moves to the loading position and is ready for
sewing.
9.2 Switching off
–
Switch off the main switch 1.
All drives and the control are immediately cut off the electric
supply lines.
Attention!
The main switch is also the emergency stop button! When the main
switch is turned off, the machine is separated from the power supply!
9.3 Threading mode
Attention!
The “Threading mode” must only be used for the operations
necessary for threading the needle thread, the looper thread and the
gimp thread! For all further operations (e.g. change of knife or cutting
block) the machine has to be switched off with the main switch!
Switching on the “Threading mode”
–
Press key 2 in the front plate. The key must engage!
The sewing automat is in the ”Threading mode".
In the “Threading mode” the key is illuminated.
The cloth carrier plate moves to the position best for threading.
The cloth clamps remain in the same position as they were when
switching on the “Threading mode”.
The sewing drive is separated from the power supply.
The knife for cutting open is switched off.
Switching off the “Threading mode”
–
Press key 2 again. The key must be released.
After a short stop the sewing automat is ready for sewing again. The
sewing operation is continued where the ”Threading mode" had been
activated.
23
1
2
