Bedienungsanleitung Edilkamin Story (Seite 38 von 209) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch)

810770

Zoom out

Zoom in

Vorherige Seite

1/209

Nächste Seite

- 38 -

ENGLISH

INSTRUCTIONS FOR USE

Pressed brieﬂ y it switches the stove from manual to automatic operating mode; held down (pressed and held for 2”)

it gives access to the various programming menus.

Each time it is pressed tells the electronic circuit board memory that 15Kg have been loaded into the tank; pressing it

continuously for 5” cancels any residual or previously loaded Kg.

Pressed brieﬂ y it switches the stove’s fan from the quieter “Comfort” level to the higher energy “Turbo” level.

1 2 3 4 5

Loading the feed screw.

Should the pellet hopper empty completely the feed screw

must be ﬁ lled. To do so, keep the + and – keys pressed simul-

taneously for a few seconds (on the remote control or synoptic

panel). Once released, ‘REFILL’ will appear on the display.

This must be carried out before ignition if the stove has stopped

due to the pellets having ﬁ nished.

It is quite normal for some pellet residue to remain inside the

hopper, this is what the feed screw is unable to pick up.

Once a month, fully vacuum the hopper to prevent dusty resi-

due from accumulating.

Automatic ignition

With the stove on standby, press the 0/1 button for 2 seconds

(on the synoptic panel or remote control). This will startup

the ignition process, ‘Start-up’ will appear on the display and

a countdown will commence in seconds (1020). There is no

preset time for the ignition process: its duration will be automa-

tically shortened if the control board detects that certain tests

have been carried out positively. The ﬂ ame appears after about

5 minutes.

Manual ignition

At a temperature lower than 3 °C – too low for the electrical

resistance to become red hot - or if the resistance is temporarily

not working, you can use a ﬁ relighter to ignite the stove.

Insert a well-lit ﬁ relighter into the combustion chamber, close

the door and press 0/1 on the synoptic panel or remote control.

Operating modes

Manual: the user sets the desired operating power (from

a minimum of 1 to a maximum of 5)

Automatic: the user sets the desired room temperature

using the +/- key or the remote control, the stove reads the

setting and adjusts the power to reach the temperature set,

then sets itself to Power 1.

Manual mode from synoptic panel/remote control

With the stove in operation mode or on standby, press and

release the MENU button on the synoptic panel/remote

control and ‘Power’ will appear on the display (showing

the power at which the stove is working). Press the + key on

the remote control to increase the operating power (from Power

1 to Power 5). Setting the fan via the Synoptic Panel

With the stove in operation mode or on standby, rotate the

right knob to adjust the ventilation setting (from 1 to 10 in

all powers).

“Touch in correspondence to the LED points to select the desired operating power.

Alternatively, the traditional setting can be used, which can be selected using the +/- buttons.”

increases the various settings

decreases the various settings; pressing for 5s locks the keypad, pressing for another 5s unlocks the keypad

MIMIC PANEL

hold down for 2 seconds to turn stove on or off

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Edilkamin Story Seite 38

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info