Bedienungsanleitung Etna EEO146A (Seite 3 von 6) (Englisch)

558367

Zoom out

Zoom in

Vorherige Seite

1/6

Nächste Seite

Instructions for Use

Description of the Appliance

Shelf (1)

The shelf may be placed randomly upon any of the guide slots

within the interior of the appliance. It is protected against

sliding out.

The shelf is placed upon the top four guides by lowering the

front section of the shelf downwards, the rear of the shelf is

placed upon the guide slot and the shelf is inserted in the guide

in the inclined position.

The shelf is placed upon the top four guides by lifting the front

section of the shelf upwards, the rear of the shelf is placed

upon the guide slot and the shelf is inserted in the guide in the

inclined position.

In case you may wish to remove the shelf from the appliance

lift the shelf by hand at the rear and pull it out in the opposite

procedure.

Glass shelves are protected with plastic edge frames.

Quickly perishable food should be stored on the back i.e. the

coldest part of the shelves.

Defrost Water Outlet (2)

The interior of the refrigerator is cooled with cooling plate

incorporated in the rear wall. Under the plate there is a channel

and an outlet for defrost water.

Regularly check the defrost water outlet and the channel,

because they should never be clogged (as for example with

food rests). If clogged, use a plastic straw and clean it.

Crisp tray and serving tray (3)

The tray at the bottom of the refrigerator is covered with the

serving tray. This cover protects the stored fruit and vegetables

from excessive drying.

Door Liner

The door liner consists of various shelves or holders used for

storing eggs, cheese, butter and yogurt as well as other

smaller packages, tubes, cans etc.

The lower shelf is used for storing bottles.

Illumination in the Interior of the Refrigerator

The light for illuminating the interior of the appliance is on,

when the door is opened. The operation of the light does not

depend on the position of the thermostat knob.

Operation Control

The appliance is controlled with thermostat knob, situated in

the right upper part inside the appliance.

Turn the knob from STOP (0) position towards 7 and

backwards.

Temperature Selection

 Higher settings on the knob (towards 7) mean lower

temperatures (colder) in all three compartments of the

appliance. Temperature in the interior of the appliance may

even drop below 0°C. Higher settings should be used only in

case higher temperature is recommended or required.

When the ambient temperature is normal, we recommend

medium setting.

 Changes of the ambient temprature affect temperature in the

interior of the appliance (choose correct setting of the

thermostat knob).

 In STOP (0) position the appliance does not operate (the

cooling system is switched off), yet power supply is not

interrupted (the light is on, when you open the refrigerator

door).

 Temperature in the refrigerator also depends on how often

the door is opened.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Etna EEO146A Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Etna EEO146A

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info