Bedienungsanleitung Etna EEO146A (Seite 5 von 6) (Englisch)

558367

Zoom out

Zoom in

Vorherige Seite

1/6

Nächste Seite

Instructions for Use

 remove the bottom board of the kitchen cabinet;

 pull the condenser dish out;

 use the vacuum cleaner to clean the dust from the condenser;

 replace the condenser dish and the bottom rail in the opposite

order.

After cleaning, connect the appliance to power supply and reload it.

Switch Off the Appliance When Not In Use

If you do not intend to use the appliance for a longer period, set the

thermostat knob to the STOP (0) position, disconnect the power

supply, take out the foods and defrost and clean the appliance. Leave

the door slightly open.

Trouble-Shooting Guide

During the service, you can come across some troubles that in

most cases result from improper handling of the appliance and

can easy be eliminated.

The Appliance Fails to Operate After Connecting to the

Mains Supply

 Check the supply in the outlet socket and make sure the

appliance is switched on (thermostat knob in operating

position).

Continuous Operation of the Cooling System

 The door was frequently opened or it was left opened for too

long.

 The door is not properly closed (the door may sag, the

gasket may be polluted or damaged).

 Perhaps you have overloaded the appliance with fresh

foods.

 Insufficient cooling of compressor and condenser.

Check the air circulation through the bottom rail openings

and if necessary clean or vacuum the dust from the

condenser. See Section Cleaning and Maintenance.

Ice Formation on the Inner Rear Wall

Until the water is drained through the hole in the rear and into

the receptacle at the bottom of the appliance, normal

automatic defrosting of the appliance is guaranteed.

In case the ice formation on the inner back wall is increased (3-

5 mm), ice should be manually defrosted.

Set the thermostat knob to STOP (0) position and leave the

door open. Never use electric devices for defrosting and do not

scrape the ice or frost layer with sharp objects.

After completed defrosting, turn the knob to desired position

and close the refrigerator door.

The cause of increased ice formation may be one of the

following:

 the door does not seal well (clean the gasket if it is

contaminated, or replace it if it is damaged);

 the door was frequently opened or it was left opened for

too long;

 the food stored in the refrigerator was warm;

 the food or dish is touching the inner back wall.

Sound alarm

The excessive dust upon the condenser is signaled by the

sound alarm, heard at each opening of the appliance door –

until the default is removed.

Check the air circulation through the bottom rail openings and

if necessary clean or vacuum the dust from the condenser.

See Section Cleaning and Maintenance.

Water drains into the bottom compartment of the

appliance

Water leaks from the refrigerator if the drain hole is clogged, or

if the water drips past the collection gutter.

 Clean the clogged outlet, for example with a plastic straw.

 Manually defrost the increased ice layer. See "Ice Formation

onthe Inner Rear Wall".

Noise

Cooling in refrigerating-freezing appliances is enabled by the

cooling system with compressor, which produces noise. How

noisy the appliance is depends on where it is placed, how it is

used and how old the appliance is.

 During the operation of the compressor the noise of liquid

is heard and when the compressor is not operating, the

refrigerant flow is heard. This is a normal condition and it

has no influence whatsoever on the lifetime of the appliance.

 After starting the appliance, the operation of the

compressor and the refrigerant flow may be louder, which

does not mean that something is wrong with the appliance

and it has no influence on the lifetime of the appliance.

Gradually the noise is reduced.

 Sometimes unusual and stronger noise is heard, which is

rather unusual for the appliance. This noise is often a

consequence of inadequate placing.

 The appliance shall be placed and levelled firmly on

solid base.

 It should not touch the wall or kitchen units standing next

to it.

 Check the accesories in the interior of the appliance,

they should be placed correctly in their positions; also

check the bottles, tins and other vessels that might

touch each other and rattle.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Etna EEO146A Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Etna EEO146A

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info