Bedienungsanleitung Eufy RoboVac L70 Hybrid - T2190 (Seite 22 von 128) (Englisch)

755671

Zoom out

Zoom in

Vorherige Seite

1/128

Nächste Seite

40 41

English English

Voice Prompt Cause and Solution

Error S5: Rolling Brush Error.

Refer to Owner's Manual or App

for help.

- Remove and clean the roller brush, roller brush

connection, roller brush cover and suction inlet before

restarting the device.

- If the issue persists, contact customer support for

help.

Error S6: Water Pump Error.

Refer to Owner's Manual or App

for help.

- Clean the water tank, water pump connection, water

pump interface, and water outlet at the bottom of the

device before restarting the device hidden under the

cloth cover.

- If the issue persists, contact customer support for

help.

Error S7: Laser Sensor Error.

Refer to Owner's Manual or App

for help.

- Check and clean the laser sensor for unknown objects

before restarting the device.

- If the issue persists, contact customer support for

help.

Wi-Fi Connection

Before Wi-Fi setup, make sure RoboVac and your Wi-Fi network meet the following

requirements.

Wi-Fi Setup Requirements

• RoboVac:

- RoboVac is fully charged and the main power switch on the bottom of RoboVac is

turned on.

- Wi-Fi status light slowly flashes blue.

• Wi-Fi Network:

- Use the correct password for your network.

- Do not use a VPN (Virtual Private Network) or Proxy Server.

- Your Wi-Fi router supports 802.11b/g/n and IPv4 protocol.

- You are using a 2.4GHz router or a dual-band router that is configured to support a

2.4GHz frequency band. RoboVac does not support 5GHz frequency band.

- If RoboVac cannot connect to the Wi-Fi network and you are using a 2.4/5GHz

mixed network, switch to a 2.4GHz network for Wi-Fi setup. You can switch back

once your setup is complete.

- When connecting to a hidden network, make sure you enter the correct network

name, SSID (case sensitive), and connecting to a 2.4GHz wireless network.

- When using a network extender/repeater, make sure the network name (SSID) and

password are the same as your primary network.

- The firewall and port settings of your Wi-Fi router allow RoboVac to connect with

the Eufy servers.

Network Security Requirement

- WPA and WPA2 using TKIP, PSK, AES/CCMP encryption.

Wi-Fi Channels

- The FCC requires that all wireless devices in the United States operate on the 1-11

wireless spectrum channels.

- Some countries outside North America can use spectrum channels higher than

channel 11. Refer to your local regulatory agency to determine which channels are

accessible.

- A future software release will support access to channels above 11 for users outside

North America. Until then, use channels 1-11.

If you cannot control RoboVac with your smartphone, try the solutions below to solve the

problem. If the problem persists, contact the eufy service center for help.

Wi-Fi Status Light Cause Solutions

Solid blue

RoboVac has

connected to your

router, but cannot

access the Internet.

• Check if your router is connected to the

Internet.

• Check with your Internet provider to

see if there is any Internet connection

problem.

Rapidly flashing

blue

RoboVac cannot

connect to your

wireless router.

• Check if you have modified your

network name and password.

• Reset Wi-Fi connection if necessary.

Refer to the “Use Your RoboVac with

the EufyHome App > Reset the Wi-Fi

connection” section in this manual.

Slowly flashing blue

Wi-Fi connection is

reset or has not been

set up before.

• Set up Wi-Fi connection with RoboVac.

Refer to the “Use Your RoboVac with

the EufyHome App” section in this

manual.

• Reset Wi-Fi connection if necessary.

Refer to the “Use Your RoboVac with

the EufyHome App > Reset the Wi-Fi

connection” section in this manual.

Off

RoboVac is turned off.

RoboVac’s power level

is low.

RoboVac is in Sleep

mode.

• Make sure RoboVac is turned on.

• Charge RoboVac by attaching it to the

Charging Base.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Eufy RoboVac L70 Hybrid - T2190 Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Eufy RoboVac L70 Hybrid - T2190

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info