Bedienungsanleitung Flyer Tour - Panasonic 2018 (Seite 162 von 224) (Deutsch, Englisch, Holländisch, Französisch, Italienisch)

780034

162

Zoom out

Zoom in

Vorherige Seite

1/224

Nächste Seite

160 161

Please do not touch the brake disc while

it is rotating. You can suffer serious inju-

ries if your nger is caught in the gaps of

a rotating disc brake.

The brake calliper and disc may get hot

during braking. You could suffer burns if

you touch this part during or directly after

braking.

Have the brake disc replaced if it is worn out or

bent. This replacement procedure must be car-

ried out by a FLYER specialist retailer.

Hydraulic brakes

It is possible that brake uid may escape from

the system due to leaky cables and connections.

This can negatively impact the effectiveness of

the brakes. Check the pipes and connections for

tightness before each ride.

Do not ride with your FLYER if uid is leaking from

the braking system. Allow a FLYER specialist re-

tailer to undertake repair work on this part imme-

diately. The danger of your brakes failing in this

condition is very high.

Formation of air bubbles in the disk

brakes

You can avoid this problem by applying

the brake lever before transport and then

xing it in this position using a strap.

This prevents any air from entering the

hydraulic system. Please note that the

brake lever may not be pulled when the

wheel has been removed. Place a spac-

er between the brake blocks if you need

to remove the wheel.

Ask for detailed instructions regarding the oper-

ation and special features of the e-bike braking

system from your FLYER specialist retailer, even

if you are an experienced cyclist. Practise in a qui-

et, safe area with no trafc.

If you have any questions about assembling, set-

ting up, servicing or operating this part of your

bike, please contact a FLYER specialist retailer.

A trigger point should be clearly noticea-

ble after approximately a third of the way

when pulling the brake lever. Do not start

to ride if the brake lever can be pulled up

to the handlebars. In this case, the

FLYER is not safe for operation. It is

then essential to visit your FLYER spe-

cialist retailer and have the brake adjust-

ed or repaired.

Brake discs and brake pads are particu-

larly subject to wear. Have these safe-

ty-related components regularly checked

for wear and changed as required by

your FLYER specialist retailer.

If the brake system needs to be cleaned, contact

your FLYER specialist retailer. The component

manufacturer's instructions on how to clean the

brake system are provided in the respective brake

system manual.

Only allow your FLYER specialist retailer to

maintain the brake system and change individual

brake system components. Only original spare

parts may be used. Otherwise it is possible that

the functionality of your FLYER e-bike may be im-

pacted or damaged.

Have the brake pads regularly checked accord-

ing to manufacturer specications by your FLYER

specialist retailer.

It is essential to switch off the electrical

operating system and remove the bat-

tery before any form of maintenance

work is carried out.

Source: Shimano®

techdocs

Switch off the operating system

Source: Shimano® techdocs

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Flyer Tour - Panasonic 2018 Seite 162

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info