INTRODUCTION
SYSTEM HOUSE CODE
In order to prevent any unauthorised attempt to operate
or disarm your system, you must configure your system
to accept radio signals only from your own system
devices. This is done by setting a series of eight
miniature (DIP) switches in all devices (except the
Control Panel) to the same ON/OFF combination (the
House Code) selected by the user/installer. The Control
Panel is then programmed to operate only with devices
set to this House Code. All detectors and Remote
Control Unit(s) must be configured with the same House
Code in order for the system to operate correctly.
Inside the Siren, Detectors and Remote Control Unit is
a series of 8 DIP switches.
The House Code is set up by moving each of the 8
switches in each device to the same randomly
selected ON/OFF sequence. When setting the DIP
switches, ensure that each switch ‘clicks’ fully into
position. Use the tip of a ballpoint pen or a small
screwdriver to move each switch in turn.
SA56
Note: It is recommended that the system House
Code is always changed to a code other than the
factory setting.
e.g.
