522136
32
Zoom out
Zoom in
Vorherige Seite
1/47
Nächste Seite
25
4. INSTALLATION
4.1 Display Unit
Mounting considerations
The display unit can be installed on a
desktop, on the overhead or flush mounted
in a panel. When choosing a mounting
location keep the following in mind:
Keep the display unit out of direct
sunlight.
The temperature and humidity should be
moderate and stable.
Locate the unit away from exhaust pipes
and vents.
The mounting location should be well
ventilated.
Mount the unit where shock and vibration
are minimal.
Keep the unit away from electromagnetic
field-generating equipment such as
motors and generators.
For maintenance and checking purposes,
leave sufficient space at the sides and
rear of the unit and leave slack in cables.
A magnetic compass will be affected if
placed too close to the display unit.
Observe the following compass safe
distances to prevent disturbance to the
magnetic compass:
Standard compass: 0.5 meters
Steering compass: 0.35 meters
Desktop, overhead mounting
1. Fix the bracket to a desktop or the
overhead with tapping screws
(supplied).
2. Loosely screw knobs into the display
unit.
3. Set the display unit to the bracket and
then tighten the knobs.
Flush mounting in a panel
See the instructions on the flush mounting
template (supplied).
4.2 Thru-hull Mount
Transducer
Transducer mounting location
The thru-hull mount transducer (520-5PSD,
520-5MSD) provides the best performance
of all, since the transducer protrudes from
the hull and the effect of air bubbles and
turbulence near the hull skin is reduced.
When the boat has a keel, the transducer
should be at least 30 cm away from it.
Typical thru-hull mountings are shown in
the figure on the next page.
The performance of this sounder is directly
related to the mounting location of the
transducer, especially for high-speed
cruising. The installation should be planned
in advance, keeping the standard cable
length (8 m) and the following factors in
mind:
Air bubbles and turbulence caused by
movement of the boat seriously degrade
the sounding capability of the transducer.
The transducer should, therefore, be
located in a position where water flow is
the smoothest. Noise from the propellers
also adversely affects performance and
the transducer should not be mounted
nearby. The lifting strakes are notorious
for creating acoustic noise, and these
must be avoided by keeping the
transducer inboard of them.
The transducer must always remain
submerged, even when the boat is rolling,
pitching or up on a plane at high speed.
www.Busse-Yachtshop.de email: info@busse-yachtshop.de
32

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Furuno LS-6100 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info