522136
33
Zoom out
Zoom in
Vorherige Seite
1/47
Nächste Seite
26
A practical choice would be somewhere
between 1/3 and 1/2 of the boat’s length
from the stern. For planing hulls, a
practical location is generally rather far
astern, so that the transducer is always in
water regardless of the planing attitude.
28
22
120
68
30
520-5PSD
24
120
68
87
520-5MSD
Unit: mm
Thru-hull mount transducer mounting
dimensions (millimeters)
Acceptable transducer mounting
locations
Position 1/2 to 1/3 of the hull
from stern.
15 to 30 cm off center line
(inside first lifting strakes.)
Within the wetted bottom area
Deadrise angle within 15°
HIGH SPEED-V HULL
Suitable transducer mounting locations
Typical thru-hull mount
transducer installations
Fairing
Block
Flat Washer
Rubber Washer
Hull
Deep-V Hull
Hull
Flat Washer
Rubber
Washer
Flat Hull
Cork
Washer
Typical thru-hull mount
transducer installations
Procedure for installing the
thru-hull mount transducer
1. With the boat hauled out of the water,
mark the location chosen for mounting
the transducer on the bottom of the hull.
2. If the hull is not level within 15° in any
direction, fairing blocks made out of teak
should be used between the transducer
and hull, both inside and outside, to
keep the transducer face parallel with
the water line. Fabricate the fairing
block as shown below and make the
entire surface as smooth as possible to
provide an undisturbed flow of water
around the transducer. The fairing block
should be smaller than the transducer
itself to provide a channel to divert
turbulent water around the sides of the
transducer rather than over its face.
www.Busse-Yachtshop.de email: info@busse-yachtshop.de
33

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Furuno LS-6100 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info