Bedienungsanleitung Futaba 6EXAP (Seite 4 von 24) (Englisch)

28983

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Aileron, Elevator & Rudder

dual rate switch

Antenna

Retractable landing

gear switch / CH.5

Flap control

dial / CH.6

Carrying handle

Liquid-crystal display

screen (LCD)

Throttle/rudder

control stick

MODE key

SELECT key

Trainer switch

Neck strap hook

Charging jack

On-off switch

Rudder trim

lever

Throttle trim

lever

DATA INPUT lever

Aileron trim lever

Elevator trim lever

Aileron/elevator

control stick

throttle cut

button

INTRODUCTION TO THE 6EXAP SYSTEM

IMPORTANT!:

Always turn on the transmitter first, then the receiver. When turning off the system, always turn off the receiver

first. The object is never to have the receiver on by itself. Otherwise, the servos or control surfaces could be damaged, or in

the case of electric-powered models, the motor may unexpectedly turn on causing severe injury.

IMPORTANT!:

Never collapse the transmitter antenna by pushing down from the top. If one of the segments becomes momentarily

stuck you may damage the antenna. Instead, collapse the antenna from the bottom, drawing in one segment at a time.

Transmitter

Transmits in both FM (PPM) and PCM by selecting modulation/cycling transmitter. Requires receiver of proper modulation. The

liquid-crystal display (LCD) on the face of the compact, ergonomically-designed case is easy to read and allows rapid data input.

The system also holds independent memories for six different models. The new, adjustable-length control sticks provide an

improved feel. External switches operate dual rates (D/R), landing gear, and trainer cord or “buddy-box” capabilities. Programming

features include servo reversing and E.P.A on all channels, dual rates, exponentials and programmable mixing. Additionally, any

one of four, factory-set, preprogrammed

“wing-type” mixers including flaperon, V-tail, elevon mixing may be selected.

Transmitter controls

The diagram and explanations briefly describe the functions of the Futaba T6EXAP transmitter. Full instructions on how to

operate the controls are provided beginning on page 9.

NOTE:

The diagram shows a Mode 2 system as supplied. (More on flight modes on page 21).

DESCRIPTIONS:

Aileron, Elevator and Rudder dual rate switch

Use this switch to “flip” between two aileron, elevator and rudder control throw settings. The throws can be set up however you

prefer, but generally, when the switch is “up” the throws are greater (“high rate”) and when the switch is “down” the throws are less

(“low rate”). This switch also flips between exponential rates (if used).

Flap control dial/Channel 6 -

This dial operates the servo connected to channel 6 in the receiver if your model has flaps this is

the control used to operate them.

Neck strap hook -

Mounting point for optional neck strap.

Aileron/elevator control stick -

Operates the servos connected to channel 1 (aileron) and channel 2 (elevator) in the receiver.

Trim levers (all) -

Used to shift the neutral or center position of each servo as labeled in the diagram.

NOTE:

The throttle trim lever is intended for fine tuning the throttle servo when the engine is at idle. Throttle trim does

not affect the throttle servo when the throttle control stick is all the way up (so idle r.p.m. can be adjusted without

affecting throttle settings through the rest of the stick movement).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Futaba 6EXAP Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info