Bedienungsanleitung Futaba 9ZHP_part2 (Seite 11 von 78) (Englisch)

29053

Zoom out

Zoom in

Vorherige Seite

1/78

Nächste Seite

COLLECTIVE PITCH FUNCTION (CPT)

(DIVING

AIR

BRAKE,

HIGH

PITCH

TRIM)

Airplane Section

This function allows diving airbrake ("minus

pitch") adjustment at low throttle and high pitch

adjustment at high throttle for consistent model

speed during vertical aerobatics. This mixing can

be turned on and off during flight with a switch.

Air brake, engine idle-up trim, and the high-side

pitch control trim can be set independently.

The

mixing switching point (minus pitch/high pitch

switching point) can be set at a selected throttle

stick position, and each trim rate can be adjusted.

The throttle delay when switching from minus

pitch to high pitch and the pitch delay when

switching from high pitch to minus pitch can also

be adjusted independently.

Setting Up Collective Pitch Function

Activation of command

In the Condition Menu, press the

CPT

key to get the

COL PITCH menu shown below. Use the

key to activate mode setting, then press the ACT or

INH keys ( F and G ) to activate or inhibit the func-

tion.

Mode setting

Idle-up

High pitch

Trim Rate setting

ON/OFF switch

setting

Trimming volume

setting

Throttle delay

setting

Pitch delay

setting

Return to

Condition screen

Mixing operation

point setting

Mode selection

Switch Point Setting

Press the B key to enter the throttle position setting

function. Then set the throttle stick to the desired switch

point, and press the

SET (F)

key.

Idle-up Trim and Delay Setting

Press the C key to enter the Idle-Up Trim rate setting

function, and set the rate with the numeric keys F to

M. The range may be set from 0 to 100%, and the initial

value is set to 0%.

Next, press the P key to enter the Throttle delay

setting function, and set the delay with the numeric keys.

The setting range is 0 to 100%, and the initial value is set

to0%.

Pitch Control Trim Rate and Delay Setting

Press

the D

key

to enter the

Pitch

Trim

Rate

setting

function. Set the desired rate with the numeric keys F to

The range may be set from 0 to 100%, and the initial

value is set to 50%.

Press the O key to activate the Pitch Delay setting

menu, and set the delay with the numeric keys

F to M .

The range may be set from 0 to 100% (initial setting is

0%).

On/Off Switch Setting

On initial setting, the activation switch for the Collec-

tive Pitch function is set as SW (E) ON at the lower posi-

tion. If you would like to change the switch or turn

mixing on all the time, call the Switch Setting screen by

pressing the

SWT

(

key. Then use the keys to

choose the desired switch location and on direction. For

more information on the switch setting method, see page

37).

Idle-Up Trim/Pitch Control Trim Setting

You may set up the Collective Pitch function so that

its effect may be changed in flight by moving a trim con-

trol. The trim control allows you to adjust the volume by

moving a slider. At initial setting, the left-side lever is set

for idle-up trim and the right-side lever is set for pitch

control trim.

Call the volume setting screen by pressing the

VOL

O key, and select the desired control using the screen

menus (for a description of the volume setting method,

see page 37).

Use the

END

(N) key to leave this menu.

Airplane Section, Page 87

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Futaba 9ZHP_part2 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info