6.4 Indicator lamp in the charging station
For a fully functional installation, the indicator lamp in the charging station must emit a solid or flashing green light. If
something else appears, follow the troubleshooting guide below.
There is more help on www.gardena.com. If you still need help, please contact GARDENA customer service.
Light Cause Action
Solid green light
Good signals No action required
Green flashing light
The signals are good and
ECO mode
is acti-
vated.
No action required. For more information on
ECO mode
, see
Settings on page 25
.
Blue flashing light
The boundary loop is not connected to the
charging station.
Check that the boundary wire connectors are
fitted properly to the charging station. See
Connecting the boundary wire on page 18
.
Break in the boundary loop. Find out where the break is. Replace the
damaged section of the loop with a new loop
wire and splice using an original coupler.
Yellow flashing light
The guide wire is not connected to the charg-
ing station.
Check that the guide wire connector is prop-
erly connected to the charging station. See
Laying and connecting the guide wire on
page 19
Break in the guide wire. Find out where the break is. Replace the
damaged section of the guide wire with a new
loop wire and splice using an original coupler.
Red flashing light
Interruption in the charging station’s antenna. Contact GARDENA customer service.
Solid red light
Fault in the circuit board or incorrect power
supply in the charging station. The fault
should be rectified by an authorized service
technician.
Contact GARDENA customer service.
367 - 004 - 16.02.2018 Troubleshooting - 45
