Bedienungsanleitung Garmin BC 40 (Seite 6 von 14) (Englisch)

691049

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

Tighten both screws.

Apply one or two layers of the included adhesive mounting

tape to the back of the flat mounting bracket, near the bottom

(optional).

The mounting tape secures the back of the mounting bracket

to your vehicle using double-sided adhesive. This helps

reduce camera vibration, especially if your vehicle does not

provide mounting holes at the bottom of the license plate.

You can stack two layers of mounting tape if one layer is not

thick enough to stick to your vehicle.

NOTE: The mounting tape does not replace the license plate

screws. You must fasten the mount and license plate to the

vehicle using at least two license plate screws, whether or

not you attach the mounting tape.

Vehicle Mount Installation for Europe

Installing the Mount on Your Vehicle

Remove the rear license plate and license plate holder from

your vehicle, and retain the license plate screws to install the

camera mount.

Place the camera mount against your vehicle, and align the

holes in the mount with the license plate mounting holes in

your vehicle.

The camera mount provides a variety of holes and slots for

universal vehicle compatibility.

NOTE: You can install the mount in either orientation. If you

are installing the mount with the camera at the top of the

license plate, you must remove, rotate, and reattach the

camera clip (Installing the Camera at the Top of Your License

Plate, page 2).

Insert the license plate screws through the mount and into

the mounting holes in your vehicle.

Fully tighten the screws.

Installing the Camera at the Top of Your License Plate

When the mount is installed on your vehicle, the Garmin logo on

the camera clip must be right-side up. Out of the box, the mount

is assembled for installing the camera at the bottom your license

plate. When installing the camera at the top of your license

plate, you must remove, rotate, and reattach the camera clip.

This allows you to properly adjust the camera angle.

If you have already installed the license plate fasteners,

remove them by prying up the end of each clip using the

notches and sliding them outward.

Using a Phillips screwdriver, fully loosen the two camera clip

screws .

Gently pry open the tabs along the outer edge of the

camera clip, and remove the camera clip from the mount.

Rotate the camera clip 180 degrees, so the Garmin logo is

facing right-side-up.

Snap the camera clip back into the mount, and tighten both

screws.

Installing Your License Plate into the Mount

Insert the edge of the license plate behind the tabs along the

narrow edge of the holder, and swing the bottom edge of the

plate into the mount.

Insert the two license plate retainer clips into the slots in the

holder, and slide them toward the middle.

Press the ends of the retainer clips until they click into the

holder.

2 Installation

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Garmin BC 40 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Garmin BC 40

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info