Bedienungsanleitung Garmin BC 40 (Seite 7 von 14) (Englisch)

691049

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

Installing AA Batteries

The device operates on two 1.5 V AA batteries (not included).

For the best results, you should use lithium batteries, which

provide extended battery life and better performance at low

temperatures.

NOTICE

Do not use AA batteries with a voltage specification higher than

1.5 V. Higher voltages will cause permanent damage to the

camera. Do not use lithium-ion rechargeable AA battery cells.

Lithium-ion batteries use a different technology that non-

rechargeable lithium batteries and may permanently damage the

camera.

Rotate both battery covers toward the front of the camera,

and remove the battery covers.

Insert a AA battery into each end of the camera, with the

positive pole facing outward.

On each battery cover, verify the gasket is clean and fully

seated in the groove.

For each battery cover, place the cover into the camera,

press it tightly into the camera, and rotate it toward the back

of the camera to lock it into place.

NOTE: Although the battery covers are interchangeable, it is

recommended to install the covers as shown in the

illustrations.

NOTICE

The camera is not water resistant if the gaskets are not clean

and properly seated, and the covers are not properly locked

into place.

Verify each cover is fully sealed and no part of either gasket

is protruding between the cover and the camera.

Installing the Camera in the Mount

Place one side of the camera into the mount, with the lens

facing outward.

Press the other side into the mount until it clicks.

Pull gently on the camera to verify both sides are locked into

the mount.

Pairing the Camera with a Garmin

Navigation Device

You can pair the camera with a compatible Garmin navigation

device. For more information about compatible Garmin devices,

go to the product page at garmin.com/bc40.

Update your navigation device to the latest software.

Your device may not support the BC 40 camera without the

latest software. For more information about updating the

software, see the owner's manual for your navigation device.

Install batteries in the camera.

The camera enters pairing mode automatically, and the LED

flashes blue while the camera is in pairing mode. The camera

remains in pairing mode for five minutes. If pairing mode

expires, you can remove and reinstall the batteries.

Bring the compatible Garmin navigation device outside your

vehicle and within 1.5 m (5 ft.) of the camera, and turn on the

navigation device.

The device detects your camera automatically and prompts

you to pair with it.

Select Yes.

TIP: If the navigation device does not detect the camera

automatically, you can select Settings > Wireless Camera >

Add New Camera to pair with it manually.

The device pairs with your camera, and the guidance line

configuration screen appears.

Use the on-screen arrows to position the guidance lines, and

select (Aligning the Guidance Lines, page 5).

If the camera or vehicle is not ideally positioned to complete

the guidance line alignment, you can complete the alignment

later from the camera settings.

Enter a name for the camera (optional).

You should use a descriptive name that clearly identifies the

location of the camera.

Select Done.

Pairing the Camera with a Garmin Navigation Device 3

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Garmin BC 40 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Garmin BC 40

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info