IMPORTANT: Ensure the container is properly locked on the motorblock and stands securely.
3. Place one hand on top of the lid. Turn the appliance on choosing a speed for your
needs (see Speedcontrol). The motor starts moving.
ATTENTION: If the motor slows down or stucks turn the appliance off
immediately to avoid overheating (see ´Trouble shooting`).
4. Turn the appliance ´Off` when the operation is finished.
5. As soon as the motor stops moving you can take the container off the motorblock
holding on to the handle. Take off the lid to check the consistency of the food or to
push down the food from the sides of the container. You can fill in more ingredients
through the refill aperture. Turn the refill lid anticlockwise and lift it. After adding the
ingredients close the refill aperture, place the container on the motorblock and make sure
it is securely locked. Turn on the appliance. Process until the food has the favoured texture.
6. Turn the appliance ´Off` as soon as you are done with operating and take the
container off the motorblock. You can pour out liquid foods.
IMPORTANT: Do not leave any food dry on the surfaces of the appliance. Always
clean the appliance right after use (see Care and Cleaning).
Care and Cleaning
WARNING: To avoid injury to persons and damage, always turn the appliance ´OFF`,
wait for the motor to stop completely and unplug the appliance, immediately after
operation and before assembling/disassembling or cleaning the appliance.
WARNING: Ware oven gloves if processing hot food. Ensure not to get burned on
spilled over liquids or steam.
ATTENTION: Do not use abrasive cleaners, cleaning pads, corrosive chemicals
(disinfectants, bleach) or any sharp or hard objects (i.e. metal scouring pads) for cleaning,
for this could damage the surfaces. Always handle the entire appliance with care
and without violence.
Cleaning the 1,5 Litre container
1. Empty the container and rise it with warm water.
2. Replace the container on the motorblock.
3. Fill the container with warm soapy water. The waterlevel should be high enough to
cover the blade with water but not too high to avoid run over liquids. Close the lid and
turn on the motor on MIX 4. Let the motor run for a few seconds.
4. Turn the motor ´Off`, wait for the blade to stop moving and take the container off
the motorblock.
32
40993_mixmax_manual.qxp 20.12.2006 11:11 Seite 32
