Bedienungsanleitung Godox V350N (Seite 7 von 14) (Englisch)

683875

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

● With high-speed sync, the faster the shutter speed, the

shorter the effective flash range.

● Multi flash mode cannot be set in high-speed sync mode.

● Over-temperature protection may be activated after 15

consecutive high-speed sync flashes.

● Try to avoid using high-speed sync flash, which will cut

short flash tube’s lifetime.

The flash output is adjustable from 1/1 full power to 1/128th power

in 1/3rd stop increments. To obtain a correct flash exposure, use a

hand-held flash meter to determine the required flash output.

Flash Mode – M: Manual Flash

Press < MODE > button so

1 that < M > is displayed.

Turn the Select Dial to choose

2 a desired flash output amount.

In high-speed sync mode,

the adjustable flash range is

1/16~1/1.

Figures displayed when reducing flash output level

Figures displayed when increasing flash output level

1/41/21/1

1/1-0.3

1/2+0.7

1/1-0.7

1/2+0.3

1/2-0.3

1/4+0.7

1/2-0.7

1/4+0.3

······

Flash Output Range

The following table makes it easier to see how the stop changes in

terms of f/stop when you increase or decrease the flash output. For

example, when you decrease the flash output to 1/2, 1/2-0.3, or 1/2-

0.7, and then increase the flash output to more than 1/2, 1/2+0.3,

1/2+0.7, and 1/1 will be displayed.

Optical S1 Secondary Unit Setting

In M manual flash mode, press the <SLAVE> button so that this

flash can function as an optic S1 secondary flash with optic sensor.

With this function, the flash will fire synchronously when the main

flash fires, the same effect as that by the use of radio triggers. This

helps create multiple lighting effects.

Optical S2 Secondary Unit Setting

Press the <SLAVE> button so that this flash can also function as an

optic S2 secondary flash with optic sensor in M manual flash mode.

This is useful when cameras have pre-flash function. With this

function, the flash will ignore a single “preflash” from the main flash

and will only fire in response to the second, actual flash from the

main unit.

● S1 and S2 optic triggering and off camera high-speed

mode are only available in M manual flash mode.

In the M mode, high-speed sync and rear curtain sync functions

can be achieved.

- 37 -

- 38 -

Shutter Sync Settings:

1. High-speed sync: press the <SYNC> button and is isplayed

on the LCD panel. Set the shutter sync speed to 1/320s (auto

FP) or 1/250s (auto FP) in Nikon camera setting. Turn the

camera dial, and the shutter speed can be set to or more than

1/250s. Check the shutter speed through the camera viewfinder

to confirm whether the FP high-speed function is used. If the

shutter speed is or over 1/250s, it means the high-speed is

booted up.

2. Second-curtain sync: press the < > on Nikon camera, and

turn the main command dial until is displayed on the panel.

Then, set the camera shutter.

MODE ZOOM SYNC SLAVE

SET

MODE ZOOM SYNC SLAVE

SET

REAR

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Godox V350N Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info